Mounting The Product On A Din Rail - Mitsubishi Electric MELIPC MI5000 Series User Manual

Mounting the product on a DIN Rail

This section shows the procedure for mounting this product on a DIN rail.
Applicable DIN rails
When mounting this product to a DIN rail, use any one of the following rail.
• TH35-7.5Fe
• TH35-7.5Al
• TH35-15Fe
■DIN rail adapter
A DIN rail adapter (sold separately) is required to mount this product to the DIN rail.
Model name Pieces
Hook A
R6DIN1 2
Interval between DIN rail mounting screws
When a DIN rail is used, tighten DIN rail mounting screws at intervals of 200 mm or less to ensure the sufficient strength of the
rail.
Tighten the DIN rail to the product mounting location using the screws in three locations, using the mounting screws and
square washers included with the DIN rail adapter.
*1 When DIN rail TH35-15Fe is used, the square washers are not required.
B
35mm
P
(3)
(1) Mounting screws (included)
(2) Mounting screws (sold separately)
(3) Stoppers
• Tighten the A mounting area using the mounting screws and square washers included with the DIN rail adapter.
• When tightening the B mounting area, use of the mounting screws and square washers included with the DIN rail adapter is
not required. Tighten the DIN rail with the mounting screws sold separately.
• Set the interval of P to 200 mm or less.
■Installation position of the square washers
(1) (2)
(3)
(1) DIN rail
(2) Square washer
(3) Mounting screw (M5×10)
(4) Mounting side (control panel, etc.)
Hook B-C
(with 2 attachment
screws mounted)
2
* 1
A
(1)
P
Side view A
Stopper Square washer
2 3
B
(2)
(3)
P P
A arrow view
(2)
(1)
Mounting screw
(M5×10)
3
(3)
(4)
2 PRODUCT INSTALLATION
2.1 Product Installation
2
23