Owner’s Record The model and serial numbers are located on the bottom of the unit. Record these numbers in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. Serial No.
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,...
For customers in Europe Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Notice for customers: The following information is only applicable to equipment sold in countries applying EU Directives. The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. The Authorized Representative for EMC and product safety is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany.
Guide to parts and controls This manual mainly explains operations using the buttons on the remote, but the same operations can also be performed using the buttons on the unit having the same or similar names. Unit – Back view –...
Remote RM-ANU082 ENTER A POWER (page 9, 15) Turns the unit on or off. B VOLTAGE SELECTOR (Only for models equipped with voltage selector) (page 8) C AC power cord (mains lead) (page 9) Connects to a wall outlet. D AUDIO IN jack (page 11) Connects to an optional audio component (such as portable digital music player).
Getting started Setting the voltage selector For models equipped with a voltage selector, set VOLTAGE SELECTOR to the position of your local power line voltage before you connect the AC power cord (mains lead). Depending on the model, the VOLTAGE SELECTOR may differ.
Turning on the unit Connect the AC power cord (mains lead) to the wall outlet. Press POWER on the back panel of the unit. The indicator on the front panel lights Playing the iPod/ iPhone You can listen to audio contents stored in the iPod/iPhone on this unit.
• Refer to the operating instructions supplied with your iPod/iPhone for details on iPod/ iPhone operations. • Sony cannot accept responsibility in the event that data recorded to iPod/iPhone is lost or damage when using an iPod/iPhone with this unit.
• Some iPod/iPhone operations may not be performed using buttons on the remote. • Depending on the connected iPod/iPhone, operations may differ. • The iPhone rings according to the ring volume set on the iPhone, even when the iPhone is placed on the unit.
Changing the battery The working distance of the remote shortens as the battery becomes exhausted. When the remote no longer operates the unit, replace the battery with a new CR2025 lithium battery. Push and hold the latch of the battery holder, then pull out the battery holder.
Changing the graphic sheet You can change the graphic sheet on the front panel according to your preference. We supply 2 graphic sheets and each graphic sheet is a two-sided printed sheet. Place the unit with the front panel facing up. Turn the “R”...
Find your problem in the troubleshooting checklist below and take the indicated corrective action. If the problem persists after doing all of the above, consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained.
Turn off the unit and remove the iPod/iPhone. Make sure there is no problem with the iPod/ iPhone. If this problem persists, contact your nearest Sony dealer. The iPod/iPhone cannot be operated. • Disconnect the iPod/iPhone and connect the iPod/iPhone again.
Optional components There is no sound. • Make sure you press the POWER on the back panel. • Press VOL + (or VOLUME + on the unit) repeatedly or adjust the volume on the connected component. • Connect the component properly while checking: –...
Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: USA model only With 8-ohm loads, both channels driven, from 120 Hz – 10 kHz; rates 10 watts per channel minimum RMS power, with no more than 0.7% total harmonic distortion from 250 milliwatts to rated output.
Compatible iPod/iPhone models with this unit You can use the following iPod/iPhone models on this unit. Update your iPod/iPhone with the latest software before using it. iPod nano 5th generation (video camera) iPhone 3G iPhone iPod 4th generation (color display) iPod touch iPhone 3GS 2nd generation...
Notes • This product has been designed specifically to work with iPod/iPhone and has been certified to meet Apple performance standards. • Use a Dock Adapter supplied with your iPod/iPhone. Otherwise, a compatible Dock Adapter will need to be purchased separately from Apple Inc. •...