Table of Contents
Advertisement
11
USE OF PRODUCT
Fig. 20: 5 Spd Dig Button
Cleaning Periods for Metal Filters
REPLACING THE LAMPS
12
REPLACING THE LAMPS
max 1 W
Fig. 21: LED REPLACEMENT
12.12.2018
22
1.
Press this button to turn on the product.Fig. 20
2.
Press this button to decrease the motor speed.Fig. 20
3.
Dig display You can follow which speed the product is cur-
rently working on this display.Fig. 20
4.
Press this button to increase the motor speed.Fig. 20
5.
When timer button is pressed, a 15-minute timer function will
be activated; display will give a signal once the timer starts
and the motor will stop automatically after 15 minutes.Fig. 20
6.
Press this button to turn on and off the lamp.Fig. 20
Filters should be cleaned when "C" signal appears on the Display
or (due to usage) every 2 or 3 weeks. To delete "C" signal after the
filters are cleaned and replaced, press and hold (
than 3 secs (when device is off). Letter "E" will appear on the Dis-
play and it will switch to normal operation. If operation before
deleting the "C" signal is required, active motor speed will appear
for 1 sec when you press (
resume running.
It indicates the maximum power consumption of the lamp. A lamp
with same power rating should be used when replacing the lamp.
To find out the power rating used in the product,
see the rating label in the product.
Push on the lamp with your hand, to remove it.
n
Separate the self adhesive tape around the lamps and the
n
body plate from each other.
Before placing the new LED lamp, remove the protective folio
n
from the frame, and then stick it on its place on the body of the
product.
HOOD USER GUIDE ENGLISH
12/12/2018
USE OF PRODUCT
) button more
) button and then the motor will
23
Advertisement
Table of Contents
