Transporting Cleaner; Using Your Cleaner - Bissell LIGHTWEIGHT 3120 User Manual

O
perations

Transporting cleaner

1. To move your cleaner from room to room, put
the handle in the upright position, tilt the cleaner
back on its rear wheels, and push forward.
2. The cleaner can also be moved by using the
carrying handle on the front.

Using your cleaner

1. Remove the plastic plug guard and dispose.
2. Unclip polarized plug from power cord.
3. Rotate the Quick Release cord wrap towards
floor and slip power cord from upper and lower
cord wraps.
4. Connect power cord plug to a polarized outlet.
5. To keep the power cord out of your way
while cleaning, place it in the cord hook near
the top of the handle.
Power Switch pedal
The power switch pedal is located on the back of
the cleaner, under the cord wraps.
1. Step on the power switch to turn the unit
"On". The rotating floor brush and suction
will start.
2. Step on the pedal again to turn the vacuum "Off".
CAUTION:
Before using your vacuum,
make sure the dirt container
is locked in place, and that
all filters (inner circular,
outer circular, and pre-
motor) are in place. Do not
operate your vacuum
without these filters.
w w w . b i s s e l l . c o m
ug010-0291_3120_507.indd 5 ug010-0291_3120_507.indd 5
Tip:
Before cleaning
under low furniture,
check for objects
that might block the
vacuum hose. Do
not pick up hard
or sharp objects
such as glass,
nails, screws, coins,
paper clips, etc.
with vacuum.
Quick
Release
Cord
Wrap
Power
Switch
Pedal
8 0 0 . 2 3 7 . 7 6 9 1
5
5/22/07 5:25:16 PM 5/22/07 5:25:16 PM