5. Secure the cable holder bracket and the slot 2 cover
panel with the screws removed in step 3 as shown in
the figure.
Connecting cable
Cable holder
bracket
B3 x 5
MVE-8000A
Connecting cable
Cable holder
bracket
Cover panel
(Slot 2)
Connecting cable
1-4-3. Installing the HK-PSU02
The HK-PSU02 is used after it is installed in the MVE-
8000A.
c
Before installing the HK-PSU02, be sure to turn off the
main power. If the HK-PSU02 is installed while the main
power is turned on, it can result in electrical shock or
damage to printed circuit boards.
Installation procedure
1. Remove the front door assembly of the MVE-8000A.
(Refer to Section 1-4-1.)
2. Remove the two screws (PSW3 x 6) fixing the power
dummy panel, and remove the power dummy panel.
n
Store the removed power dummy panel in a safe place.
Power dummy panel
PSW3 x 6
1-7