Overview; Intended Purpose - Silvercrest SFS 110 B2 Operating Instructions Manual

__CPE281169_Folienschweissgeraet_B4.book Seite 3 Montag, 19. September 2016 3:02 15

1. Overview

1 Red LED lights up during sealing
2 Button: film sealing (no vacuum)
3 Button: stop (cancels all active functions immediately)
4 Button: air suction (vacuum) and film sealing
5 Green LED, lights up while the air is extracted
6 Power cable with mains plug
7 Opening for the power cable on the underside of the device
8 Button for opening the lid (left and right)
9 Sealing strip
10 Upper sealing ring
11 Lid
12 Rear limitation webs
13 Suction nozzle
14 Welding wire
15 Lateral limitation webs
16 Bottom sealing ring
17 Cable spool at the underside of the device
A roll of film tube: not shown
Thank you for your trust!
Congratulations to your new bag sealer.
For a safe handling of the product and in or-
der to get to know the entire scope of fea-
tures:
• Thoroughly read these operating
instructions prior to initial use.
• Above all, observe the safety in-
structions!
• The device should only be used
as described in these operating
instructions.
• Keep these operating instruc-
tions for information purposes.
• If you pass the device on to
someone else, please include
these operating instructions. The
operating instructions are a part
of the product.
We hope you enjoy your new bag sealer!

2. Intended purpose

Use the device exclusively for the bag seal-
ing or vacuum-packing and bag sealing of
food.
The device is designed for private home use
and must not be used for commercial pur-
poses.
The device must only be used indoors.
Foreseeable misuse
WARNING! Risk of material
damage!
Only use special plastic films suited for
the use with bag sealers. Comply with
the notes on the packaging of the plas-
tic films.
3
GB