Vacuum-Pack And Seal The Bag; Cleaning And Storage; Cleaning - Silvercrest SFS 110 B2 Operating Instructions Manual

__CPE281169_Folienschweissgeraet_B4.book Seite 8 Montag, 19. September 2016 3:02 15
7. Press the button 2
lights up. The film is being sealed.
- After approx. 5 - 7 seconds, the red
LED 1 goes out and the sealing pro-
cess is completed.
8. Simultaneously, press buttons 8 in order
to release the lock of the lid 11.
9. Open the lid 11 and remove the bag.
10. Check the welding seam. It should be a
smooth creaseless seam.
8.3 Vacuum-pack and seal
the bag
DANGER! Risk of electric
shock due to moisture!
For vacuum packing, no liquids must be
inside the bag.
Ensure that no liquid is sucked in during
the extraction of air. If this occurs, interrupt
the process by pressing the button 3
1. Smooth the bag where it is to be
sealed.
2. Open the lid 11.
3. Figure A: place the bag in the device.
For this purpose, the end of the film
must be positioned shortly in front of the
rear limitation webs 12 and the lateral
limitation webs 15.
4. Ensure again that there are no creases
in the film - especially in the area above
the welding wire 14.
5. Close the lid 11.
6. Figure B: use both hands to press firm-
ly on the edges of the lid 11. They must
engage audibly.
7. Press the button 4
lights up. The vacuuming starts.
- After the vacuuming, the green LED 5
goes out and the red LED 1 lights up -
the sealing process is active. After ap-
prox. 5 - 7 seconds, the red LED 1
goes out and the sealing process is
completed.
8
GB
. The red LED 1 8. Simultaneously, press buttons 8 in order
to release the lock of the lid 11.
9. Open the lid 11 and remove the bag.
10. Check the welding seam. It should be a
smooth creaseless seam.
9. Cleaning and
Allow the device to cool down com-
pletely before you clean it or put it
away.
The welding wire 14 becomes very hot
during operation. Do not touch the hot
welding wire 14.
.
Prior to cleaning, disconnect the mains
plug 6 of the device.
The device, the power cable 6 and the
mains plug must not be immersed in
water or any other liquids.
WARNING! Risk of material
damage!
Do not use any astringent or abrasive
cleaning agents.
9.1
In order to ensure the proper function and
. The green LED 5
the full capacity of your device, clean it reg-
ularly.
• Wipe down the housing of the device
with a damp cloth.
• Prior to the next use, the device must be
completely dry.
storage
DANGER! Risk of injury
through burning/scalding!
DANGER! Risk of electric
shock!
DANGER! Risk of electric
shock due to moisture!

Cleaning