Cleaning; Troubleshooting - Silvercrest SHLF 2000 A1 Operating Instructions Manual

RP53439 HL mit FB LB4 Seite 10 Dienstag, 13. Juli 2010 3:13 15
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of an
electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
2. Remove any remaining dirt with a soft
brush.
Fault
Appliance cannot be Faulty fuse or wall socket
switched on
Faulty appliance
Appliance cannot be Faulty electronic components Have repairs carried out at a specialist
switched off
Appliance switches Safety switch has triggered
off automatically
Thermal cut-out has
triggered
10

6. Cleaning

Take care not to let any dust fall inside
the appliance. You should therefore hold
the appliance so that the protective
guard you are in the process of cleaning
is facing downwards.
3. Clean the outside of the appliance with a
damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth moiste-
ned with clear water.
5. Do not use the appliance again until it
has dried completely.

7. Troubleshooting

Cause
Select another wall socket
Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
"10. Warranty" on page 12.
workshop or dispose of the appliance.
You will find the service address in
"10. Warranty" on page 12.
Set the appliance upright (see
"5.9 Safety switch" on page 9)
Allow the appliance to cool down (see
"5.8 Thermal cut-out" on page 9)
Clean the appliance (see "6. Cleaning"
on page 10)
Remedy