Safety System - Silvercrest SSHK 100 A2 Operating Manual

Neck & shoulder heating pad
Hide thumbs Also See for SSHK 100 A2:
Table of Contents

Advertisement

Available languages

Available languages

Important safety instructions / Safety system / Preparations for use
Do not cover the control
on the heating pad when the pad is in operation.
The electronic components in the control
the heating pad cause the control
up slightly during operation.
Do not pull, twist or crease the cables. This
may damage the heating pad.

Safety system

Note: the heating pad is equipped with a safety
system. The electronic sensor technology prevents the
entire surface of the heating pad from overheating
by automatically switching off in the event of a fault.
If the safety system switches the heating pad off auto-
matically due to a fault, then the function display
on the control unit
is no longer illuminated, even
1
if the heating pad is switched on.
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.
Preparations for use
Note: the heating pad may smell of plastic the
first time you use it, but this will disappear after a
short period of time.
To begin, first connect the control
heating pad with the plug-in connector
(see Fig. B).
Place the heating pad in position as shown in
Fig. C.
Press the two ends of the heating pad together
to allow the snap fastener
You can use the snap fasteners
a closer fit.
To remove the heating pad, release the snap
fastener
or the snap fasteners
4
and do not place it
1
of
1
to heat
Switching on:
1
Switching off:
2
Selecting the temperature:
to the
1
Level 0:
3
Level 1:
Level 2–5: individual heat
Level 6:
to snap into place.
4
if you wish
5
Note: The heating pad switches itself off auto-
.
matically after about 90 minutes. The function
5
display then starts to flash.
Switching on / off / Selecting
the temperature
Set Level 1, 2, 3, 4, 5 or 6 on the control
to switch the heating pad on.
Note: The function display
after the heating pad is switched on.
Note: Note: this heating pad features rapid
heating, which allows it to heat up within the
first 10 minutes of operation.
Set Level 0 on the control
heating pad off.
Note: the function display
illuminate.
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
If you are going to use the heating pad for a
number of hours, set it to the lowest temperature
setting (setting 1).
Temperature levels
Set the required temperature level on the
control
(see Fig. A).
1
off
minimum heat
maximum heat
Automatic switch-off
Then select the setting 0 and after about
5 seconds, reset the heating pad to the desired
temperature setting to switch it on again.
1
illuminates
2
to switch the
1
ceases to
2
GB
9

Advertisement

Table of Contents
loading

Table of Contents