Sony KP-43T70C Service Manual page 37

[RED REGISTRATION ADJUSTMENT]
<RED CENTER>
1. Change to VPNT mode and set VPNT 28 RON to "001", 29
GON to "001" and 30 BON to "000" to show the green and
red colors.
2. Change the VPNT mode to the PJE mode.
3. Press 3 key on the remote commander to shift the GRN
mode to the RED mode.
4. Select RED CENT with the 1 and 4 keys on the remote
commander.
5. Adjust the red crosshatch lines go straight vertically and
horizontally and overlaps the green lines with the joystick on
the remote commander.
<RED SKEW>
1. Select RED SKEW with the 1 and 4 keys on the remote
commander.
2. Adjust the red crosshatch lines go straight vertically and
horizontally and overlaps the green lines with the joystick on
the remote commander.
<RED LINEARITY>
1. Select RED SIZE (vertically and horizontally) or RED LIN
(vertically) with the 1 and 4 keys on the remote com-
mander and adjust while tracking each other alternately.
2. Adjust the red crosshatch lines go straight vertically and
horizontally and overlaps the green lines with the joystick on
the remote commander.
<RED KEY>
1. Select RED KEY with the 1 and 4 keys on the remote
commander.
2. Adjust the red crosshatch lines go straight horizontally and
overlaps the green lines
with the joystick on the remote commander.
<RED PINCUSHION>
1. Select RED PIN with the 1 and 4 keys on the remote
commander.
2. Adjust the red crosshatch lines go straight horizontally and
overlaps the green lines with the joystick on the remote
commander.
<FINE ADJUSTMENT>
1. Press 9 key on the remote commander to shift to the fine
adjustment mode.
The red marker (in the RED mode) appears on the center of the
screen.
KP-43T70C/53SV70C/61SV70C
2. Use the 1 and 4 keys or the joystick on the remote com-
mander, move the marker everywhere you want to adjust and
adjust with the joystick on the remote commander.
[BLUE REGISTRATION ADJUSTMENT]
1. Change to VPNT mode and set VPNT 28 RON to "001", 29
GON to "001" and 30 BON to "001" to show full color.
2. Change the VPNT mode to the PJE mode.
3. Press 3 key on the remote commander to shift the RED mode
to the BLU mode.
4. Adjust BLU CENT, BLU SKEW, BLU SIZE, BLU LIN, BLU
KEY and BLU PIN in the same procedure of the red registra-
tion adjustment.
[FINAL CHECK]
1. Store the new adjustment (offset) value on the remote control
by pressing [MUTING] and [ENTER].
2. Press the FLASH FOCUS button on the front panel.
(The Offset value is now automatically stored.)
3. Check that no error message appears.
If an error message appears, recheck.
– 37 –
RM-Y906 RM-Y906 RM-Y906