Two Vcrs For Tape Editing - Sony Qualia 006 Owner's Manual

Setting Up the SXRD Projection TV
Two VCRs for Tape
Editing
Using
S VIDEO jacks?
See page 40.
Cables are often
color-coded to connectors.
Connect red to red,
white to white, etc.
VCR (playback)
44
If you connect two VCRs, you can record from one VCR to the other while
using your SXRD projection TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1
Using A/V cables, connect the playback VCR's AUDIO and VIDEO
OUT jacks to the recording VCR's AUDIO and VIDEO IN jacks.
2
Using A/V cables, connect the recording VCR's AUDIO and VIDEO
OUT jacks to the SXRD projection TV's AUDIO and VIDEO IN jacks.
A/V cable
✍
To perform tape editing, set the SXRD projection TV to the video input
intended for playback by pressing TV/VIDEO on the remote control.
✍
You may need to change the video input on your VCR. See your VCR's
operating manual for instructions.
✍
If your VCRs have S VIDEO jacks: For best picture quality, use an
S VIDEO connection instead of the yellow video cable on your combined
A/V cable.
Using an S VIDEO cable, connect the playback VCR's S VIDEO OUT jack
to the recording VCR's S VIDEO IN jack. S VIDEO does not provide
audio, so audio cables must be connected to provide sound.
✍
You cannot record signals from equipment connected to the Y, P
input.
Rear of SXRD projection TV
VCR (recording)
AUDIO-R
AUDIO-L
VIDEO
A/V cable
, P
B R