Table of Contents
Advertisement
Parameterization
9.4 Parameters
P02
Designation on ATC
display
P02.32
POST-TRANSFER
TIME 1
P02.33
PRE-TRANSFER
TIME 2
P02.34
POST-TRANSFER
TIME 2
P02.37
CONT. COM. TB IN
OFF
P02.39
TB. EN. CONDITION
P02.40
CHANNEL NO.
P02.43
INTERLOCK TB
164
Description
Post-transfer time Load 1
– After a transfer between the sources, this parame-
ter defines when the Post-transfer Load 1 output is
enabled. For more information, see chapter Table of
functions of the digital outputs (Page 150).
Pre-transfer time Load 2
– Delay between enabling the output Pre-transfer
Load 2 and the actual shutting down of the load. An
output must be parameterized with the function Pre-
transfer time Load 2 for this purpose. For more
information, see chapter Table of functions of the
digital outputs (Page 150).
Post-transfer time Load 2
– After a transfer between the sources, this parame-
ter defines when the Post-transfer Load 2 output is
enabled. For more information, see chapter Table of
functions of the digital outputs (Page 150).
Continuous command of tie breaker TB in OFF
mode
– This specifies the behavior of the opening/closing
command outputs in the continuous signal mode, if
the ATC6500 is in the OFF mode. Used in applica-
tions with contactors.
OFF – Opens the command outputs
NOC – Leaves the outputs unchanged
Enabling of tie breaker TB
– This parameter enables you to specify how and
whether the tie breaker is to be controlled.
OFF = The tie breaker is controlled normally
Other selection = The tie breaker can only be con-
trolled if the selected condition is met.
Example: On selecting INPx, the tie breaker can
only be controlled if the corresponding input is ac-
tive.
Function index
– Index that is possibly assigned to the function
programmed in the previous parameter. Example:
The tie breaker TB should only be controllable if the
input 4 has been enabled: P02.39 = INPx P0240 =
4
Interlock time of tie breaker TB
– Delay that elapses between disconnection of the
tie breaker and the opening command for the
source breakers.
Unit
Default
Range
s
OFF
OFF /
1...1000
s
OFF
OFF /
1...1000
s
OFF
OFF /
1...1000
NOC
OFF
NOC
OFF
OFF
INPx
OUTx
LIMx
REMx
Ax
UAx
TIMx
OFF
OFF / 1-99
sec
6
0.1 - 1800
3KC ATC6500 transfer control device
Manual, 05/2019, L1V30538268002A-01
Advertisement
Table of Contents
