Table of Contents
Advertisement
Connecting two VCRs for tape
editing
By connecting a second VCR to MONITOR
OUT, you can record a program being played
by the primary VCR to the second VCR or
perform tape editing and dubbing.
1
Connect the VCR intended for playback
using the connection instructions on page
10 of this manual.
2
Using an AUDIO/VIDEO cable, connect
AUDIO and VIDEO IN on the VCR
intended for recording to AUDIO and
VIDEO OUT of MONITOR OUT on the
projection TV.
Notes:
• Do not change the input signal while
editing through MONITOR OUT.
• When connecting a single VCR to the
projection TV: if VCR LINE OUT is
connected to VIDEO IN on the projection
TV, do not connect MONITOR OUT on
the projection TV to the VCR LINE
INPUT (see right). Doing so will cause
program interference and other viewing
problems.
Disconnect all power sources before making any connections.
S VIDEO
VIDEO
L
(MONO)
AUDIO
R
VCR (for playback)
S-LINK
AUDIO R AUDIO L VIDEO
OUT
LINE
OUT
IN
AUDIO-R
AUDIO-L
VIDEO
VMC-810S/820S
(not supplied)
1
(Rear of projectionTV)
VIDEO IN
VCR
(Rear of projection TV)
IN
VIDEO 1 VIDEO 3
VIDEO 4
VIDEO 5
Y
OUT
TV
MONITOR AUDIO
P
B
(VAR/FIX)
P
R
VIDEO
L
L
(MONO)
AUDIO
AUDIO
R
R
S-LINK
AUDIO
VIDEO 1 VIDEO 3
VIDEO 4
VIDEO 5
TV
MONITOR
(VAR/FIX)
IN
OUT
VIDEO
AUDIO-L
AUDIO-R
VMC-810S/820S
(not supplied)
MONITOR
OUT
Indicates direction
of signal
LINE
IN
OUT
AUX
TO
CONVERTER
VHF/UHF
VCR (for recording)
AUDIO R AUDIO L VIDEO
OUT
LINE
IN
IN
2
15
Advertisement
Table of Contents
