Sony GRAND WEGA KDF-60XBR950 Operating Instructions Manual page 30

Installing and Connecting the LCD Projection TV
Cable Box Only
30
For best results, use this connection if:
❑
Your cable company scrambles all channels, which requires you to use a
cable box.
❑
You do not have a VCR. (If you have a VCR, see pages 32 and 33.)
With this connection you can:
❑
Use the LCD projection TV remote control to change channels coming
through the cable box to the LCD projection TV's VHF/UHF jack. (You
must first program the remote control for your specific cable box.)
About Using This Connection with Dual Picture (Twin View, etc.)
Features
With this connection, all channels come into the LCD projection TV through your
cable box and only one unscrambled signal is sent to the LCD projection TV, so you
cannot use the dual picture features. If some of your channels are scrambled, but
others are not, consider using the "Cable Box and Cable Only" connection on page
28 instead.
To connect the cable box
1
Connect the CATV cable to the cable box's input jack.
2
Use a coaxial cable to connect the cable box's output jack to the LCD
projection TV's VHF/UHF jack.
3
Run the Auto Setup program, as described in "Setting Up the LCD
Projection TV Automatically" on page 45.
Coaxial cable
CATV cable
IN
Cable box
Notes on Using This Connection
To do this...
Use the cable box
Set up the LCD
projection TV remote
control to operate the
cable box
VHF/UHF
OUT
Do This ...
Tune the LCD projection TV to the channel the cable box
is set to (usually channel 3 or 4) and then use the cable box
to switch channels.
Program the remote control. See "Programming the
Remote Control" on pages 48.
Rear of LCD projection TV