Problems Related To Paper Feeding And Output - Sharp MX-B400P Operation Manual

PROBLEMS RELATED TO PAPER FEEDING AND
OUTPUT
Problem
The paper misfeeds.
Point to check
Is a torn piece of paper remaining in the
machine?
Is too much paper loaded in the tray?
Are multiple sheets feeding at once?
Are you using paper that is not within
the specifications?
Has the paper in the tray absorbed
moisture?
Are the bypass tray guides adjusted to
the width of the paper?
Is the bypass tray extension pulled out?
Is the bypass feed roller dirty?
Has the correct paper size been set?
Did you add paper to the bypass tray?
Make sure all paper is removed.
☞
REMOVING MISFEEDS
Make sure that the stack of paper in the tray is not
higher than the indicator line.
Fan the paper well before loading it.
Use SHARP-recommended paper. Using paper that is
not supported may result in misfeeds, creases, or
smudges.
Please use SHARP-recommended paper and label
sheets.
For paper that is prohibited or not recommended, see
"USEABLE PAPER" (page 1-37) in "1. BEFORE USING
THE MACHINE".
If you will not be using paper in a tray for a long time,
remove the paper from the tray and store it in a bag in a
dark and dry location.
Adjust the bypass tray guides to the width of the paper.
When loading a large size of paper, pull out the
extension.
Clean the surface of the bypass feed roller.
☞
1. BEFORE USING THE MACHINE
THE BYPASS FEED
If you are using a special size, be sure to specify the
paper size.
If the size of paper loaded in a tray was changed, be
sure to check the paper size setting.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings"
When adding paper, remove any paper remaining in the
bypass tray, combine it with the paper to be added, and
reload as a single stack. If paper is added without
removing the remaining paper, a misfeed may result.
4-17
TROUBLESHOOTING
Solution
(page 4-2)
"CLEANING
ROLLER" (page 1-67)