Connections; Connecting Video Equipment - Sony UP-21MD Instructions For Use Manual
Color video printer
Hide thumbs
Also See for UP-21MD:
- Product manual (25 pages) ,
- Instructions for use manual (360 pages) ,
- Service manual (83 pages)
Table of Contents
Advertisement
Connections
To enable printing, video equipment to act as an input
signal source, and a video monitor to display images or
menus must be connected.
The following diagrams illustrate how to make the input,
output and remote control connections. Use this as a
guide when connecting the cables required to transmit
signals to and from the equipment to be used for
printing.
Notes
• Turn off the power of each device before attempting to
make any connections.
• Connect the AC power cord last.
Connecting Video Equipment
Connect the video equipment providing the video
images to be printed.
Connect the video equipment which will be used in
actual printing, using the following diagram as a guide.
Before connecting the video equipment, see “Important
safeguards/notices for use in the medical environments”
on page 2.
Connections
Video equipment
to RGB
to composite
output
video output
connectors
connector
to S VIDEO
75-ohm
75-ohm
output
coaxial cable
coaxial cable
connector
with BNC
with BNC
connectors
connectors
Connecting
cable (with
DIN 4-pin
to S
connectors)
VIDEO
b)
to RGB SYNC
INPUT
INPUT
to VIDEO
INPUT
UP-21MD
to AC IN
a)
NTSC/PAL selector
AC power cord
(supplied)
to wall outlet
a) Set the NTSC/PAL selector to match your TV system. To
switch the TV system, turn the power off once, then change
the setting. If you change the setting with the power on, this
mode will not be switched.
b) Only for the UP-21MD.
Page 10
Hide quick links:
Advertisement
Table of Contents
