Low Latency; System Settings - NovaStar MCTRL660 PRO User Manual

MCTRL660 PRO Independent Controller
User Manual
Backup 2
Backup 3

7.8.9 Low Latency




Figure 7-24 Ethernet port loading cabinets vertically

System Settings

Figure 7-25 System settings
www.novastar.tech
DVI
SDI
The MCTRL660 PRO supports a low latency of less than 1 ms (when the start
position of image is 0). Low latency is used to reduce the time delay between the
input of video signal to the controller and the corresponding output. To enable
low latency, you need to set the horizontal resolution loaded by a single Ethernet
port less than or equal to 512 pixels.
Low latency cannot be enabled with any of the following functions at the same
time.
Image mirroring
−
Input of interlaced SDI video sources
−
GENLOCK
−
Each Ethernet port must load the cabinets vertically in the configured screen, as
shown in Figure 7-24.
7 Menu Operations
NULL/SDI/HDMI
NULL/DVI/HDMI
28