Oil Change/Filter - Polaris TRAIL BOSS 325 2001 Manual

ENGINE OIL LEVEL
To check the oil level:
1. Set machine on a level surface.
2. Start and run engine for 20-30 seconds. This will return
oil to its true level in the engine sump..
3. Stop engine, remove dipstick and wipe dry with a clean
cloth.
4. Reinstall dipstick, screwing into place.
NOTE: The dipstick must be screwed completely in to en-
sure accurate measurement.
5. Remove dipstick and check to see that the oil level is in
the normal range. Add oil as indicated by the level on
the dipstick. Do not overfill.
NOTE: Rising oil level between checks in cool weather
driving, can indicate moisture collecting in the oil reservoir.
If the oil level is over the full mark, change the oil.
OIL AND FILTER CHANGE
1. Place vehicle on a level surface.
2. Run engine two to three minutes until warm. Stop
engine.
3. Clean area around drain plug.
4. Place a drain pan beneath engine crankcase and
remove drain plug. CAUTION: Oil may be hot. Do not
allow hot oil to come into contact with skin as serious
burns may result.
5. Allow oil to drain completely.
6. Replace sealing washer on drain plug. NOTE: The
sealing surfaces on drain plug and crankcase should be
clean and free of burrs, nicks or scratches.
7. Reinstall drain plug and torque to 14 ft. lbs. (19 Nm).
Recommended Engine Oil:
Polaris Premium 4 All Season
Synthetic, 0W-40
Ambient Temperature Range:
-40q F to 120q F
MAINTENANCE
ADD 8 OZ. NORMAL
Maintain Oil Level In Normal Range
Screw in completely to check
Crankcase Drain
Engine Sump Drain Plug - Bottom View
FULL
2.19