Section 3. Generator Probe Maintenance; Disassembly; Bearing Removal - Omni TISSUE MASTER 125 User Manual

SECTION 3. GENERATOR PROBE & ACCESSORY MAINTENANCE
In order to thoroughly clean the components of the Tissue Master, it
must be disassembled.

3.1 DISASSEMBLY

1. Disconnect the MOTOR from the power source.
2. Unthread the GENERATOR TUBE from the motor unit.
3. Hold down the SHAFT LOCK BUTTON. Use the collet wrench to
loosen (counterclockwise) and remove the COLLET NUT.
4. Remove the steel ROTOR SHAFT from the COLLET NUT and FLEXIBLE
COLLET.
5. If the BEARING is worn, it needs to be replaced (see Section 3.2).
If the BEARING does not need replacing, wipe the rotor shaft with
a cloth or paper towel. Use the included brush to clean inside
the generator tube.
Shaft Lock
Button

3.2 BEARING REMOVAL

1. Hold the BEARING/ROTOR SHAFT with a pair of pliers.
2. Use a sharp knife to cut the BEARING lengthwise.
3. Peel the BEARING off of the shaft and discard.
WARNING: DO NOT
while cutting.
Motor
Collet Nut
Rotor Shaft
hold the bearing/rotor shaft with bare hands
7
Flexible Collet
(black)
Generator Tube
Bearing (white)