Mounting The Transport Data Logger Tdl140 - Bosch TDL140 Operating Instructions Manual

3. Mounting the TDL
Freight Guard – TDL140
Before mounting please insert the TDL140 into the
mounting plate as seen below. Please be aware that
TDL140 unit can be correctly inserted into
the bracket part only in one specific position.
Hold the unit slightly tilted to slide it into the
bracket.
Then, push the unit further inside the bracket until
both parts fit together.
The TDL140 can be attached to any cargo in any
position required.
The fastening, depending on the specific require-
ments, can be carried out with screws or with
double-sided adhesive tape. In case shock shall be
measured a direct and non-absorbing connection
between the mounted TDL140 and the monitored
goods is required. For achieving this we recommend
using either screws or a fiber-reinforced adhesive
tape.
Recommended screws: M4 (recommended with washer)
raised cheese head / pan head / round head screws.
Recommended tightening torque: 1 Nm
Recommended tape: Double-sided fiber-reinforced
adhesive tape.
CAUTION: Check Housing
Do not use de device if you see any signs of
manipulation or damage in the housing. Please
contact Bosch Connected Devices and Solutions for more
information.
5