Table of Contents
Advertisement
Miscellaneous
Precautions
Safety
• Operate the printer using the power source specified in
"Specifications" (page 20).
• Be careful not to damage the power cable by placing or
dropping heavy objects on it; it is dangerous to use the
unit with a damaged power cable.
• If you do not intend to use the printer for a long time,
press the 1 ON/STANDBY switch on the printer to
enter the standby state and then remove the power plug.
• Unplug the power cable by grasping the plug, not the
cable itself.
• Do not disassemble the unit. There is a danger of electric
shock from the internal parts.
• Be careful not to spill water or other liquids on the unit, or
to allow combustible or metallic material to enter the
cabinet. If used with foreign matter in the cabinet, the unit
is liable to fail, or present a risk of fire or electric shock.
• If the unit malfunctions or if a foreign body falls into the
cabinet, disconnect the power immediately and consult
your Sony service facility or your Sony dealer.
Installation
• Avoid placing the unit in a location subject to:
– mechanical vibration
– high humidity
– excessive dust
– direct or excessive sunlight
– extremely high or low temperatures
• Ventilation holes are provided on the back of the unit to
prevent the unit from overheating. Be careful not to
obstruct them with other objects or by covering the unit
with a cloth etc.
On condensation
• If the printer is subjected to wide and sudden changes in
temperature, such as when it is moved from a cold room
to a warm room or when it is left in a room with a heater
that tends to produce quantities of moisture,
condensation may form inside the printer. In such cases
the printer will probably not work properly, and may
even develop a fault if you persist in using it. If moisture
condensation forms, turn off the power and leave the
printer standing for at least one hour.
• If the printing pack is subjected to wide and sudden
changes in temperature, condensation may form on the
ink ribbon or paper inside. This will cause the printer to
16
Precautions
malfunction. Also, if the printing pack is used in this
state, spots are likely to appear on the printout.
• To store a half-used printing pack, replace it in its
original packing and reseal the package. If possible, keep
the sealed printing pack in a cool, dark location. To
subsequently use the printing pack, place it, in its sealed
package, in a warm room for several hours. Doing so
prevents condensation from forming when the printing
pack is removed from its package.
Transportation
When transporting the printer, be certain to first
remove all accessories, including the ink ribbon and
paper. Carrying the printer with accessories installed can
later cause the printer to malfunction. It is recommended
that the ink ribbon and paper roll be stored in their original
bags.
Transporting the printer with scraps (created during
printing) inside the paper cover may also result in
malfunction. Before transporting the printer, be sure to
perform the procedure in "Removing Scraps" on page 14
to remove the scraps.
Cleaning
Note
Before you clean the printer, be sure to press the 1 ON/
STANDBY switch to enter the standby state and then
remove the power plug.
When the cabinet becomes dirty
Clean the cabinet, panel and controls with a soft dry cloth,
or a soft cloth lightly moistened with a mild detergent
solution.
Do not use any type of solvent, such as alcohol or benzene
or chemical cloth, which may damage the finish.
Cleaning the Internals of the Printer
Perform thermal head cleaning if lines and marks appear
on printouts, and perform roller cleaning if scratches
appear at regular intervals.
Thermal head cleaning
To maintain print quality, we recommend that you perform
regular thermal head cleaning once a month or once after
every 10 printing packs used.
1
Make sure that the printer is not performing an
operation, and then pull out the media tray.
2
Confirm whether there is paper inside.
Hide quick links:
Advertisement
Table of Contents
