Toshiba e-STUDIO A Series Operator's Manual page 25

3.Setting the IP Fax Function
Item name
10 Proxy Server Setting - Primary
11 Proxy Server Setting -
Secondary
12 T.38 Transport
13 T.38 Media Type
14 T.38 Reception Port Number
15 RTP Reception Port Number
16 Incoming Reply Delay Time
17 Maximum Use Bandwidth
(kbps)
* If IPv6 is used for Server IP Address, put the value in brackets ([ ]). (Link Local Address is not available.)
Example: [2001:0db8::1234:5678:90ab:cdef]
When the settings are specified for both [Primary] and [Secondary] in [Proxy
Server Setting], those for [Primary] are used.
Server IP Address * — Enters the host name or the IP address of a primary
proxy server. You can enter up to 128 characters. This will not be displayed if
[Auto(DHCP)] or [Auto(DHCPv6)] has been selected in Address Mode.
Port Number — Enters the port number for sending packets to a primary
registrar. You can enter a value in the range from 1 to 65535. Generally the
default value "5060" is used.
User Name — Enters a user name to be authenticated in a primary proxy
server. You can enter up to 64 characters.
Password — Enters a password to be authenticated in a primary proxy
server. You can enter up to 64 characters.
Retype Password — Enters the same password again for a confirmation.
When a primary proxy server cannot be used, a secondary one will be
utilized.
Server IP Address * — Enters the host name or the IP address of a
secondary proxy server. You can enter up to 128 characters. This will not be
displayed if [Auto] or [Auto(DHCPv6)] has been selected in Address Mode.
Port Number — Enters the port number for sending packets to a secondary
proxy server. You can enter a value in the range from 1 to 65535. Generally
the default value "5060" is used.
User Name — Enters a user name to be authenticated in a secondary proxy
server. You can enter up to 64 characters.
Password — Enters a password to be authenticated in a secondary proxy
server.
You can enter up to 64 characters.
Retype Password — Enters the same password again for a confirmation.
Sets the transport protocol to be used preferentially in the T.38 session.
After the SIP session has been established, select the protocol for sending/
receiving data.
 UDP — Select this to use UDP.
 TCP — Select this to use TCP.
Sets the type of the media stream to be used in the T.38 session.
After the SIP session has been established, select the type of the media
stream for sending/receiving data.
 Image — Select this to send or receive data in an image format.
 Application — Select this to send or receive data in an application format.
Enters the port number for receiving the T.38 session. You can enter a value
in the range from 1 to 65535. Generally the default value "5006" is used.
Enters the port number for receiving RTP (Real-time Transport Protocol).
You can enter a value in the range from 1 to 65535. Generally the default
value "5004" is used.
Enters the delay time until the reception operation has started after it has
been detected.
You can enter a value in the range from 0 to 32 sec. Generally the default
value "0" is used.
Enters the maximum bandwidth for IP Fax communication. You can enter a
value in the range from 64 to 65535. Generally the default value "1000" is
used.
Description
Setting the IP Fax Function from TopAccess 25