Table of Contents
Advertisement
Error E5B5-xx16 due to the deformation of shutter for waste paper
case assembly (Perfect Binder_B1 / Perfect Binder_D1)
[Symptom]
Error E5B5-xx16 may occur at the time of bookbinding printing.
- Error E5B5-xx16 : Waste paper detection error for Perfect Binder
[Cause]
Normally, waste paper [1] generated at the time of trimming goes into the waste paper buffer [2]. When waste paper goes into
the gap [4] between the waste paper buffer [2] and shutter [3] due to some factors, the shutter will be deformed if the operation
is continued as it is. The above symptom occurs because the deformation of shutter disables to lock the sub-buffer. The following
figure [A] indicates the normal drop position of the waste paper. The following figure [B] indicates the state that the waste paper
goes into the gap between the waste paper buffer [2] and shutter.
[Servicing Work]
When the above symptom occurs, prepare the new type shutter (FLO-0749-000) and sheet (4A3-2553-000) to replace with them
following the procedure below. The following procedure describes from the steps after separating Perfect Binder from the main
body. Even error is not displayed, there is a possibility of the deformation of shutter. Check if there is a deformation of shutter
executing below step 1) at the time of periodical checking or so, if possible. When the deformation is found, replace the shutter
with new type shutter.
1) Checking the deformation of shutter for waste paper case assembly.
1-1) Pull out the waste paper basket to take out waste paper box from it.
1-2) Check the gap [a] located between the shutter [1] and stacking tray sensor [2] from the place that waste paper basket is
pulled out.
When the gap [a] is 9 mm or more, the shutter is not deformed. Other causes may be possible.
When the gap [a] is less than 9 mm, the shutter is deformed. Proceed to step 2).
192
Hide quick links:
Advertisement
Table of Contents
