E5B5-Xx16 Due To Sliding Failure Of The Waste Stopper In The Waste Paper Case Assembly(Perfect Binder-A1,Perfect Binder-C1 ) - Canon Perfect Binder A1 Troubleshooting Manual

Copier B/W | imagePRESS 1135/1125/1110 Series |
E5B5-xx16 due to sliding failure of the waste stopper in the waste
paper case assembly(Perfect Binder-A1,Perfect Binder-C1 )
[Symptom]
E5B5-xx16 error may occur during bookbinding operation.
- E5B5-xx16 error: Waste detection error of Perfect binder
[Cause]
Waste paper [1], generated upon trimming, normally falls into the waste paper buffer [2]. In some cases, the waste paper [1] may
go into the space [4] between the waste paper buffer and the waste stopper [3]. If the waste paper goes in the space, the frictional
resistance increases at the front of the waste stopper. This prevents proper operation, resulting in the symptom.
Figure [A] below shows paper waste that has properly fallen. Figure [B] shows the state in which waste paper has gone into the
space between the waste paper buffer and the waste stopper.
[Service work]
When the above mentioned symptom has occurred, prepare and replace with the Dust Stopper Unit (FM1-D248-000) following
the procedure below. The procedure below starts from the step after disconnected Perfect binder from the copier main body.
1) Checking sliding failure of the Waste stopper
1-1) Open the front cover (Right/Left).
1-2) While holding the front cover (Left), remove the upper/lower hinges to remove the front cover (Left). Pull the hinge in the
direction of arrow while pushing the black lever to remove the hinge.
134