Channels Setup - Hitachi Ultravision C55M6 Owner's Manual

Channels setup

This TV is equipped with a Channel List
feature which allows channels to skip up
or down to the next channel set into the
Channel List, skipping over unwanted
channels.
Before selecting channels, they must be
scanned into the TV's Channel List.
Air/Cable selection
1
Select "Channels" ⇒ "Source".
2
Press ◀ or ▶ to select "Air" or "Cable".
Air - VHF/UHF channels
Cable - CABLE TV channels
NOTE:
• It may take a few seconds for a digital
channel picture to appear on screen after
being selected.
Auto Channel Scan
1
Select "Channels" ⇒ "Auto Channel Scan",
then press SELECT.
2
In the confirmation window, press ▶ to
select "Yes". The TV will begin scanning all
the channels available in your area.
• It may take from 15 minutes to 30
minutes to complete channel scan.
• Depending on the reception condition
the progress bar may not advance for
several minutes, please be patient.
• If you press EXIT while scanning, the
channel scan will stop.
NOTE:
• If you are unsure of the digital channels
available in your area, you may visit www.
antennaweb.org to receive a list based on
your address or zip code. If you require
further assistance you may call our toll-
free customer service line at 800.HITACHI
(800.448.2244) (USA).
• New channels may be added to your area
periodically, it is recommended to perform
the "Auto Channel Scan" procedure
regularly.
3
The new channels will be added into the
channel list.
EN23