Pci Configuration Status And Error Messages - Sony PCV-RX465DS System Reference Manual

98
VAIO Digital Studio™ System Reference Manual

PCI Configuration Status and Error Messages

The following is a list of status and error messages that may appear on
your system from time to time.
Message
Floppy Disk Controller
Resource Conflict
NVRAM Checksum Error,
NVRAM Cleared
NVRAM Cleared By Jumper
NVRAM Data Invalid,
NVRAM Cleared
Parallel Port Resource Conflict
PCI Error Log is Full
PCI I/O Port Conflict
PCI IRQ Conflict
PCI Memory Conflict
Primary Boot Device Not
Found
Primary IDE Controller
Resource Conflict
Primary Input Device Not
Found
Primary Output Device Not
Found
Secondary IDE Controller
Resource Conflict
Serial Port 1 Resource Conflict
Meaning
The floppy disk controller has requested a
resource that is already in use.
The NVRAM data was reinitialized due to
an NVRAM checksum error.
The Clear CMOS jumper block has been
changed to the clear position.
Invalid entry in the NVRAM.
The parallel port has requested a resource
that is already in use.
This message is displayed when more than
15 PCI conflict errors are detected. No
additional PCI errors can be logged.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
The designated primary boot device (hard
disk drive, floppy disk drive, CD-ROM
drive, or network drive) could not be
found.
The primary IDE controller has requested a
resource that is already in use.
The designated primary input device
(keyboard, mouse, or other, if input is
redirected) could not be found.
The designated primary output device
(display, serial port, or other, if input is
redirected) could not be found.
The secondary IDE controller has requested
a resource that is already in use.
Serial port 1 has requested a resource that is
already in use.