Download Print this page

Before First Use - Electrolux ESP4SL10SP User Manual

Automatic coffee maker
Hide thumbs

Advertisement

10
www.electrolux.com

BEFORE FIRST USE

5.
5.1 Controls after transport
After removing the packaging, check
that the appliance is intact and that all
accessories are included. Do not use the
appliance if it is visibly damaged. Contact
Customer Services.
5.2 Initial cleaning
Coffee has been used to factory-test the
appliance and it is therefore completely
normal for there to be traces of coffee in
the grinder.
Customise water hardness as
soon as possible following the
instructions in the "Setting water
hardness" section.
5.3 Installing the appliance
IMPORTANT!
• Installation must be performed by a
qualified professional in compliance
with legislation in force in the country
of installation (see Built-in installation).
• The packing elements (plastic bags,
polystyrene foam, etc.) should be kept
out of reach of children.
• Do not install the appliance in rooms
where the temperature may drop to
0°C or lower.
• Customise the water hardness as soon
as possible following the instructions in
the "Setting water hardness" section.
5.4 First connection
Connect the appliance to the mains
electricity supply and make sure the main
switch (A10) on the side of the appliance
is pressed down (fig. 1);
Turn the rotary (C2) (fig. 2 Quick Guide)
to select the required "Language", then
press the rotary to confirm;
Turn the rotary again to select "Display
Brightness" and press it to confirm. Turn
the rotary to set from 1 to 5 level.
Turn the rotary to select "Time of day"
and press it to confirm. Turn the rotary to
select "Minute of the day" and press it to
confirm. Turn the rotary to set the hours
and minutes until the current time is
displayed and press it to confirm.
Turn the rotary to select "demo mode" or
"First use setup".
First use setup:
• FILL TANK WATER is displayed:
remove the water tank (A6), open the
lid, fill to the MAX line (marked on the
inside of the tank) with fresh water (fig.
4 Quick Guide), close the lid and put
the tank back in the appliance;
• INSERT WATER SPOUT is displayed:
Check that the hot water/steam spout
(B6) is inserted on the connection noz-
zle (A5) (fig. 5 Quick Guide) and place
a container holding a minimum of 100
ml underneath;
• PLACE A CUP UNDER THE WATER
SPOUT PRESS OK TO START DE-
LIVERING THE HOT WATER appears
on the display;
• Select OK to confirm. The appliance
delivers water from the spout then
fig. 1

Advertisement

loading

This manual is also suitable for:

Esp4sl10cn