General - Siemens SINAMICS G130 Operating Instructions Manual

General

Description
The line filters limit the conducted interference emitted by the converter units to permissible
values.
To reduce emissions, the Power Modules are equipped as standard with a line filter in
accordance with the limit values defined in category C3 (environment 2). The additional line
filters described here can be fitted for use in environment 1 (category C2).
In conjunction with line reactors, line filters limit the conducted interference emitted by the
Power Modules to the limit values defined in product standard EN 61800-3. Provided that the
system has been set up in accordance with the EMC installation guidelines, the limit values
at the installation location will be in accordance with the requirements for environment 1.
Danger to life if the fundamental safety instructions and remaining risks are not carefully
observed
The non-observance of the fundamental safety instructions and residual risks stated in
Chapter 1 can result in accidents with severe injuries or death.
• Adhere to the fundamental safety instructions.
• When assessing the risk, take into account residual risks.
Risk of burns due to high surface temperatures of the line filter
The line filter can become very hot. You can get seriously burnt when touching the surface.
• Mount the line filter so that contact is not possible. If this is not possible, attach a clearly
• To prevent adjacent components from suffering damage due to these high
Line filter
Operating Instructions, 04/2014, A5E00331460A
WARNING
CAUTION
visible and understandable warning notice at hazardous positions.
temperatures, maintain a clearance of 100 mm on all sides of the line filter.
2
13