Sony Walkman WM-FX493 Operating Instructions

3-867-999-33(1)
Radio
Cassette Player
WALKMAN is a registered trademark of Sony Corporation.
WALKMAN
Operating instructions The CE mark on the Walkman is valid only for
products marketed in the European Union.
WM-FX493/FX491
Sony Corporation © 2000 Printed in Malaysia
A
B
FWD
FX493
Y•x (RADIO
REV
ON/BAND•OFF)
VOL
OPEN
HOLD
MB MODE TAPE AVLS FM MODE
FF/PRESET +
REW/PRESET –
SET
FX493
MENU ENTER
VOL
HOLDB Plug in firmly.
FX491
TUNING+/–
TUNING
Y
x/RADIO OFF
x Y
REW RADIO OFF FF
FF/PRESET+
RADIO ON
REW/PRESET– BAND
PRESET PRESET
RADIO ON /BAND
C
FX493 FX491
SET
SET
MENU
MENU
Specifications Battery life (approximate hours)
Sony alkaline LR6 (SG)
• Frequency range
Tape playback 25
FM: 87.5–108 MHz
AM: 531–1602 kHz Radio reception 40
• Power requirements
3 V DC batteries R6 (size AA) x 2
* Measured value by the standard of JEITA (Japan
• Dimensions (w/h/d) Electronics and Information Technology Industries
Approx. 115.8 x 83.2 x 30.1 mm, incl. projecting parts and Association). (Using a Sony HF series cassette tape)
controls
Note
• Mass
• The battery life may shorten depending on the operation
Approx. 115 g/Approx. 195 g (incl. a battery and a cassette)
of the unit.
• Supplied accessories
Stereo headphones or earphones with remote control (1)
(FX493)/Stereo headphones or earphones (1) (FX491)
Design and specifications are subject to change without notice.
English
To improve the broadcast reception
Preparations
• For FM: Extend the headphones/earphones cord
(antenna) (FX491) or remote control cord (antenna)
To Insert Batteries
A
(FX493). If the reception is still not good, press
MENU repeatedly to set the cursor in the display to
1 Slide and open the battery compartment lid,
FM MODE. Then press SET to switch between
and insert two R6 (size AA) dry batteries
"MONO" (monaural) and none (stereo) for best
with correct polarity.
reception.
• For AM: Reorient the unit itself.
Replace the batteries with new ones when " "
flashes in the display. Presetting Radio Stations
You can store radio stations into the unit's memory.
You can preset up to 32 radio stations, 8 for each
Playing a Tape
B
FM1, FM2, FM3 or AM bands.
1 If the HOLD function is turned on, slide the
1 Press RADIO ON/BAND to turn on the
HOLD switch in the opposite direction of
radio.
the arrow to unlock the controls.
2 Press RADIO ON/BAND repeatedly to
2 Insert a cassette and press MENU
select AM, FM1, FM2 or FM3.
repeatedly to set the cursor to TAPE in the
3 Press ENTER.
display. Then press SET to select the tape
type. The frequency digits and a preset number
flash in the display.
No message: normal (TYPE I)
METAL: CrO (TYPE II) or metal (TYPE IV) 4 While the frequency digits and the preset
2
number are flashing, tune in to a station you
3 Press Y on the main unit, or if using the
wish to store using TUNING+/–, and select
remote control (FX493 only), press Y
a preset number using PRESET+/–.
(play)•x (stop).
5 While the frequency digits and the preset
Adjust the volume with VOL.
number are flashing, press ENTER.
When adjusting the volume on the Walkman (FX493
only) Notes
Set the VOL control on the remote control at maximum.
• If you cannot complete step 4 or 5 while the indications
are flashing, repeat from step 3.
When adjusting the volume on the remote control • If a station is already stored, the new station replaces
(FX493 only) the old one.
Set the VOL control on the Walkman slightly above the
appropriate level. To cancel the stored station
Follow the procedure above and in step 3, instead of
Note on the cassette holder
tuning in to a station, press and hold TUNING +/– until
When opening the cassette holder, press the x (stop)
"- - - -" is displayed. Press ENTER while "- - - -" is
button and make sure the tape is stopped by checking flashing.
through the cassette window, then slide the OPEN
switch.
To play the preset radio stations
If the cassette holder is opened before the tape is
stopped, the tape may loosen and be damaged. 1 Press RADIO ON/BAND to select the band.
2 Press PRESET+/–.
Operation on the main unit
To
Press
To operate from the remote control
Switch playback to Y (play)during playback (FX493 only)
the other side
To turn on the radio, press RADIO ON/BAND•OFF
Stop playback for more than one second (only while the tape is in
x
stop mode).
To select the band, press RADIO ON/BAND•OFF
Operation on the remote control (FX493
for more than one second while the radio is on.
only)
To tune in or recall a preset station, press PRESET +
To Press or –.
To turn off the radio, press RADIO ON/BAND•OFF.
Switch playback to
Y•x for 2 seconds or
the other side
more during playback
Using Other Functions
Stop playback Y•x once during
playback
To lock the controls
Set the HOLD switch to the direction of the arrow to
Other tape operations
lock the controls.
To
Press
To emphasize bass sound
Fast forward* FF during stop
Rewind* Press MENU repeatedly to set the cursor to MB in the
REW during stop
display. Then, press SET to turn MB on. With each
Play the same side from REW during playback
press, the indications change as follows.
the beginning (Auto
MB (MEGA BASS) : emphasizes bass sound
Play function)
No message: off (normal)
Play the other side from
FF during playback
the beginning (Skip Notes
Reverse function)
• If the sound is distorted with the mode "MB", turn
down the volume of the main unit or select normal
mode.
* For FX493 only: If Y•x on the remote control is
• Bass emphasis may not show great effect if the volume
pressed during fast forward or rewind, the Walkman
switches to playback. is turned up too high.
To protect your hearing—AVLS
To select playback mode
Press MENU repeatedly to set the cursor to MODE in (Automatic Volume Limiter System)
the display. function
Then press SET to select the desired mode.
When you set the AVLS function to active, the
maximum volume is kept down to protect your ears.
To play Select
Press MENU repeatedly to set the cursor to AVLS in
Both sides repeatedly s
the display. Then press SET to show "
Both sides once from
d
Note
the side facing the
• The AVLS setting will be canceled when you replace
cassette holder
the batteries.
Listening to the Radio
B
(JEITA*)
1 If the HOLD function is turned on, slide the
Sony R6P (SR)
HOLD switch in the opposite direction of
7.5
the arrow to unlock the controls.
14
2 Press RADIO ON/BAND to turn on the
radio.
3 Press RADIO ON/BAND repeatedly to
select AM, FM1, FM2 or FM3.
4 Press TUNING +/– to tune in to the desired
station.
If you keep pressing TUNING+/– for a few
seconds, the Walkman will start tuning to
the stations automatically.
To turn off the radio
Press x•RADIO OFF.
C
Precautions
On batteries
• Do not carry dry batteries with coins or other metallic objects.
1
It can generate heat if the positive and negative terminals of
the batteries are accidentally contacted by a metallic object.
• When you are not going to use your Walkman for a long
time, remove the batteries to prevent damage from battery
leakage and corrosion.
On handling
• Do not leave the unit in a location near heat sources, or in a
place subject to direct sunlight, excessive dust or sand,
moisture, rain, mechanical shock, or in a car with its
windows closed.
• Do not use cassettes longer than 90 minutes except for long
1
continuous playback.
• The LCD display may become hard to see or slow down
when using the unit at high temperatures (above 40°C/
104°F) or at low temperatures (below 0°C/32°F). At room
temperature, the display will return to its normal operating
condition.
• If the unit has not been used for a long time, set it in the 2
playback mode to warm it up for a few minutes before
inserting a cassette.
On the remote control (FX493 only)
Use the supplied remote control only with this unit.
On headphones/earphones
Road safety
IV
Do not use headphones/earphones while driving, cycling, or
3
operating any motorized vehicle. It may create a traffic hazard
and is illegal in some areas. It can also be potentially dangerous
to play your headphones/earphones at high volume while
walking, especially at pedestrian crossings.
You should exercise extreme caution or discontinue use in
potentially hazardous situations.
Preventing hearing damage
Do not use headphones/earphones at high volume. Hearing
experts advise against continuous, loud and extended play. If
you experience a ringing in your ears, reduce volume or
discontinue use.
Caring for others
Keep the volume at a moderate level. This will allow you to hear
outside sounds and to be considerate to the people around you.
On maintenance
•To clean the tape head and path, use the cleaning cassette
CHK-1W (not supplied) every 10 hours of use.
Use only the recommended cleaning cassette.
•To clean the exterior, use a soft cloth slightly moistened in
water. Do not use alcohol, benzine or thinner.
•Clean the headphones/earphones and remote control plugs
periodically.
Troubleshooting
The display shows incorrect information.
• The batteries are weak. Replace the batteries with new ones.
The display and the operation are not normal.
• Remove the power sources for 15 seconds or more, and then
set them again.
".
Y•x
B
A
1
2
3
B
4
x•
C
•
I
II
Y
Y
•x
•
1
2
x
3
4
Y
5
x
•
•
Y•x
Y•x
1
2
•
•
•
s
d
•
•
•
•
•
•
•
•
•
•
•
•
•
•