Getting Started; Resetting The Unit; Preparing The Card Remote Commander; Setting The Clock - Sony MEX-BT2600 Operating Instructions Manual

Getting Started

Resetting the unit

Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel and press the RESET
button with a pointed object, such as a ball-point
pen.
RESET
button
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
Preparing the card remote
commander
Before using the card remote commander for the
first time, remove the insulation film.
Tip
For how to replace the battery, see "Replacing the
lithium battery of the card remote commander" on
page 21.
6

Setting the clock

The clock uses a 24-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "CLOCK-ADJ" appears.
3
Press (SEEK) +.
The hour indication flashes.
4
Rotate the volume control dial to set
the hour and minute.
To move the digital indication, press (SEEK)
–/+.
5
Press the select button.
The setup is complete and the clock starts.
To display the clock, press (DSPL). Press
(DSPL) again to return to the previous display.
Tip
You can set the clock automatically with the RDS
feature (page 12).
Adjusting the volume level of
each device
When connecting to a portable audio device via
Bluetooth connection or AUX input jack, we
recommend adjusting the volume level of the
connected device, or adjusting the volume level
for each connected device in the setup menu on
this unit. For Bluetooth device, see "Adjusting
the volume level" on page 15. For a device
connected to AUX, see "Adjust the volume level"
on page 17.