Troubleshooting
Specifications
Should any problem persist after you have
System
made these checks, consult your nearest Sony
Audio playing system
dealer.
MiniDisc digital audio system
Laser diode properties
Material: GaAlAs
The player does not work or works
Wavelength: λ = 790 nm
poorly.
Emission duration: continuous
• You tried to play with no disc in the
Laser output: less than 44.6 µW*
player (“No DISC” flashes).
* This output is the value measured at a distance
b Insert an MD.
of 200 mm from the objective lens surface on
• The player is locked.
the optical pick-up block with 7mm aperture.
b Slide HOLD against the arrow to
Revolutions
unlock the player.
400 rpm to 900 rpm (CLV)
• Moisture has condensed inside the
Error correction
player.
Advanced Cross Interleave Reed Solomon Code
b Take the MD out and leave the
(ACIRC)
player in a warm place for several
Sampling frequency
hours until the moisture evaporates.
44.1 kHz
• The rechargeable battery or dry battery
Coding
are weak (n“LoBATT”
Adaptive TRansform Acoustic Coding (ATRAC)
flashes).
Modulation system
EFM (Eight to Fourteen Modulation)
b Replace the dry battery or recharge
Number of channels
the battery.
2 stereo channels
• The rechargeable battery or dry battery
1 monaural channel
have been installed incorrectly.
Frequency response
b Install the battery correctly.
20 to 20,000 Hz ± 3 dB
• An MD with no recording on it is
Wow and Flutter
inserted (“BLANK” flashes).
Below measurable limit
b Insert a recorded MD.
Outputs
• The player cannot read the disc (it’s
Headphones: stereo mini-jack, maximum output
scratched or dirty) (“ERROR” flashes).
level 5 mW + 5 mW, load impedance 16 ohm
b Reinsert or replace the disc.
• While operating, the player received a
General
mechanical shock, too much static,
Power requirements
abnormal power voltage caused by
Nickel cadmium rechargeable battery NC-6WM
lightning, etc.
(supplied)
b Restart the operation as follows.
One LR6 (size AA) battery (not supplied)
Sony AC Power Adaptor AC-E15L
1)
(not
1 Disconnect all the power sources.
supplied) connected at the DC IN 1.5 V jack
2 Leave the player for about 30
Battery operation time
seconds.
See “When to replace or charge the battery”
3 Connect the power source.
Dimensions
The MD is not played normally.
Approx. 80 × 18.5 × 104 mm (w/h/d) (3
×
1
/
4
× 4
•The player is set to the repeat mode
3
1
/
/
in.) not including projecting parts and
4
8
(“f“ is displayed).
controls
b Press PLAY MODE repeatedly until
Mass
“f“ disappears, then start
Approx. 160 g (5.6 oz.) the player only
Approx. 200 g (7.1 oz.) incl. a premastered MD,
playing.
and a nickel cadmium rechargeable battery NC-
6WM
An MD is not played from the first track.
Supplied accessories
• Disc playing stopped before it came to
Battery Charger (1)
the last track.
Rechargeable battery (1): NC-6WM, 1.2V,
b Press = repeatedly or eject and
600mAh Ni-Cd
reinsert the MD once to go back to
Rechargeable battery carrying case (1)
the beginning of the disc, and restart
Headphones with a remote control (1)
Carrying pouch (1)
playing after checking the track
Ear pad (2) (Excluding U.S.A. model)
number in the display.
Playback sound skips.
Optional accessories
1)
AC-E15L AC power adaptor
• The player is placed where it receives
MDR-series Stereo headphones
2)
continuous vibration.
SRS-A41 Sony Active Speakers
b Put the player on a stable place.
CK-MD4 MiniDisc Carrying Case
A very short track may cause sound
CK-MD10 MiniDisc Filing Box
to skip.
Sound has a lot of static.
1)
The operative voltage for the AC power
• Strong magnetism from a television or
adaptor varies depending upon the country in
such device is interfering with
which it is sold. Therefore, purchase the AC
power adaptor in the country you intend to
operation.
use it.
b Move away from the source of
2)
Whether you should plug the headphones
strong magnetism.
directly to 2/REMOTE on the main unit or to
Charging the rechargeable battery does
a remote control, use only headphones with
not start. (in case of the charger with a
stereo mini plugs.
lid)
stereo mini plugs
• The lid of the battery charger is not
closed properly.
b Close the lid and slide the switch on
it.
No sound comes through the
headphones.
• The headphones plug is not firmly
Your dealer may not handle some of the above
connected.
listed accessories. Please ask the dealer for
detailed information about the accessories in
b Connect the headphones plug firmly
your country.
to the remote control. Then connect
the remote control plug firmly to the
2/REMOTE jack.
US and foreign patents licensed from Dolby
• Volume is too low.
Laboratories Licensing Corporation.
b Adjust the volume by pressing
VOLUME +/– .
Design and specifications are subject to change
• AVLS is on.
without notice.
b Slide AVLS to NORM.