Sony M-565V Operating Instructions (primary manual) Operating Instructions

3-241-559-23 (1)
™
Microcassette -Corder
Operating Instructions
Mode d'emploi (voir verso)
M-650V/565V/560V
Sony Corporation © 2002 Printed in China
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.

About This Manual

The instructions in this manual are for 3 models. The M-650V is
the model used for illustration purposes.
Their differences are shown in the table below:
M-650V M-565V/560V
Tape counter a a
MIC jack a —
REC lamp a —
BATT/E lamp a —
REC/BATT lamp — a
VOR
a a
FAST PB a —
Handstrap a —
a: provided or supplied
—: not provided or not supplied
There is no difference between M-565V and M-560V except for the
supplied accessories.
For information about the supplied accessories, see "Specifications" of
this manual.
Preparing Power Sources
Choose one of the following power sources.
Dry Batteries
Insert the # side
first for each
battery.
Make sure that nothing is connected to the DC IN 3V jack.
1 Open the battery compartment lid.
2 Insert two size AA (R6) batteries with correct polarity and
close the lid.
To take out the batteries
If the battery compartment lid is accidentally
detached
Attach it as illustrated.
When to replace the batteries
For M-565V/560V
Replace the batteries with new ones when the REC/BATT lamp
dims.
For M-650V
Replace the batteries with new ones when the BATT lamp goes
off and the E lamp flashes.
Notes
• The unit will play back normally for a while, even after the E lamp
flashes. However, replace the batteries as soon as you can. If you do not,
the playback cannot be made with normal sound, noise may be
recorded and the recorded sound will not be loud enough (M-650V
only).
• In the following cases you do not need to replace the batteries:
– if the BATT lamp flashes with the playback sound when you turn up
the volume.
– if the E lamp lights momentarily when the tape starts running or at
the end of the tape (M-650V only).
– if the E lamp flashes during FF (CUE) or REW (REVIEW) (M-650V
only).
Battery life (Approx. hours)
Batteries Recording
Sony manganese R6P (SR) 8 (M-650V only) 10 (M-565V/560V only)
Sony alkaline LR6 (SG)** 26 (M-650V only) 30 (M-565V/560V only)
* Measured valued by the standard of JEITA (Japan Electronics and
Information Technology Industries Association) (Using a Sony
Microcassette)
**When using a Sony LR6 (SG) "STAMINA" alkaline dry batteries
(produced in Japan)
Note
The battery life may shorten depending on the operation of the unit.
House current
to the wall outlet
AC power adaptor (not supplied)
Connect the AC power adaptor to DC IN 3V and to a wall outlet.
Use the AC-E30HG AC power adaptor (not supplied). Do not
use any other AC power adaptor.
Polarity of the plug
Note
Specifications for AC-E30HG vary for each area.
Check your local voltage and the shape of plug before purchasing.
Recording
Make sure that nothing is connected to MIC (M-650V only).
EAR
REC (M-650V only)
REC/BATT (M-565V/
560V only)
TAPE SPEED
VOR
tape counter
BATT/E
(M-650V only)
Tx
1 Press the reset button of the tape counter.
2
Press Tx and insert a standard microcassette with the side
to start recording facing the lid.
3 Select the desired tape speed.
2.4 cm for optimum sound (recommended for normal use):
A 30-minute recording can be made using both sides of the
MC-30 microcassette.
1.2 cm for longer recording time: A 60-minute recording can
be made using both sides of the MC-30 microcassette.
4 Set VOR to H, L or OFF.
If you set VOR to H or L, the unit automatically starts
recording the sound and pauses when there is no sound
(you can save tapes and batteries).
H : To record at meeting or in a quiet and/or spacious place.
L : To record for dictation or in a noisy place.
When the sound is not loud enough, set it to OFF, or the unit
may not start recording.
5 Press z.
n is pressed simultaneously and recording starts. While
the tape runs, the REC lamp lights and flashes depending on
the strength of the sound.
Recording level is fixed.
To Press or slide
Tx
Stop recording
Start recording during z during playback (the unit becomes in the
playback recording mode)
Review the portion just Push up mCUE/MREVIEW toward
recorded MREVIEW during the recording. Release the
button at the point to start playback.
Pause recording Slide >PAUSE in the direction of the arrow.
Take out a cassette Tx
Note
Select the 2.4 cm tape speed for recording, if you play back the recorded
tape with another unit. Otherwise, the sound quality may be changed.
Notes on VOR (Voice Operated Recording)
• The VOR system depends on the environmental conditions. If you
cannot get the desired results, set VOR to OFF.
• When you use the unit in a noisy place, it will stay in the recording
mode. If the sound is too soft, on the contrary, the unit will not start
recording. Set VOR to H (high) or L (low) depending on the conditions.
To monitor the sound
Connect an earphone (not supplied) to EAR jack. The monitor
volume cannot be adjusted by VOL.
To prevent a cassette from being accidentally recorded
over
Break out and remove the cassette tabs. To reuse the cassette for
recording, cover the tab hole with adhesive tape.
(JEITA*)

Playing a Tape

EAR
MIC (PLUG IN POWER)
(M-650V only)
TAPE SPEED
Microphone
> PAUSE
z
m CUE/
REVIEW M BATT/E
(M-650V only)
Tx
1 Insert a cassette with the side to start playing facing the lid.
2 Select the tape speed to the same speed as that used for
recording.
3 Press n.
4 Turn VOL to adjust the volume.
If you plug in headphones (not supplied) to the EAR jack, you
will get monaural output from both left and right channels.
To
Stop playback/stop fast
forward or rewind*
Pause playback
Fast forward
Rewind
Search forward during
playback (CUE)
Search backward during
playback (REVIEW)
* If you leave the unit after the tape has been wound or rewound, the
batteries will be consumed rapidly. Be sure to depress Tx.
Note
If the tape is completely wound or rewound while searching forward/
backward during playback (CUE/REVIEW), the mCUE/MREVIEW
switch may not return to the center position when you release the switch.
In this case, push back the switch to the center to start playback.
To increase the playback speed (M-650V only)
Slide the FAST PB switch in the direction of the arrow. The
playback speed will be increased.
To return to the original speed, slide the FAST PB switch to the
original position.
At the end of the tape
In the recording or playback mode, the tape stops at the end of
the tape and the locked buttons will be released automatically
(Automatic shut-off mechanism).
After fast forward or rewind, be sure to set mCUE/
MREVIEW back to the center.
Recording/Playback with the
Connected Equipment
(M-650V only)
Recording with an External Microphone
Connect a microphone to the MIC jack. Use a microphone of low
impedance (less than 3 k ) such as ECM-T6 (not supplied).
When using a plug-in-power system microphone, the power to
the microphone is supplied from this unit.
Note
When recording with an external microphone, the VOR system may not
work properly because of the difference in sensitivity.
Recording from another tape recorder
Connect another tape recorder to the MIC jack using the
RK-G64HG connecting cord (not supplied).
Set this unit to the recording mode and another tape recorder to
the playback mode. In this case set VOR to OFF.
Precautions
On power
•Operate the unit only on 3 V DC.
For AC operation, use the AC adaptor recommended for the
unit. Do not use any other type. For battery operation, use two
size AA (R6) batteries.
On the unit
•Use only the
unit. Non-standard cassettes cannot be used because their "L"
dimension (see illustration) is different.
Standard
Only standard microcassettes
have a small indention of side A.
Approx. 5 mm
•Do not leave the unit in a location near heat sources, or in a
place subject to direct sunlight, excessive dust or mechanical
shock.
•Should any solid object or liquid fall into the unit, remove the
batteries or disconnect the AC power adaptor, and have the
unit checked by qualified personnel before operating it any
further.
•Keep personal credit cards using magnetic coding or spring-
wound watches etc. away from the unit to prevent possible
damage from the magnet used for the speaker.
•When you do not use the unit for long, remove the batteries to
avoid damage caused by battery leakage and subsequent
corrosion.
•If the unit has not been used for long, set it in the playback
mode and warm it up for a few minutes before inserting a
cassette.

Troubleshooting

Should any problem persist after you have made these checks,
VOL
consult your nearest Sony dealer.
A cassette cannot be inserted.
t The cassette is being inserted in the wrong way.
> PAUSE
t n has been already pressed.
n
The unit does not operate.
m CUE/
t The batteries have been inserted with incorrect polarity.
REVIEW M
t The batteries are weak. Replace both batteries with new
ones.
Tx
t >PAUSE is slid in the direction of the arrow.
t The AC power adaptor is connected to the unit only and
FAST PB
you are going to use the unit on batteries.
(M-650V only)
Recording cannot be made.
t There is no cassette in the cassette compartment.
t The tab on the tape has been removed. To reuse the tape
for recording, cover the tab hole with adhesive tape.
Recording is interrupted.
t The VOR switch is set to H or L. When you do not use
VOR, set it to OFF.
During CUE/REVIEW the tape stops or does not run.
You cannot fast-forward or rewind.
t The batteries are weak. Replace both batteries with new
ones.
Recording cannot be erased completely.
t The head is contaminated. See "Maintenance".
Press or slide
Playback cannnot be made.
Tx
t The tape has reached the end. Rewind the tape.
No sound comes from the speaker.
Slide >PAUSE in the direction of the
t The earphone is plugged in.
arrow. REC (M-650V) or REC/BATT
t The volume is turned down completely.
(M-565V/560V) lamp goes off.
The sound drops out or comes with excessive noise.
Slide mCUE/MREVIEW toward
t The volume is turned down completely.
mCUE during stop.
t The batteries are weak. Replace both batteries with new
Slide mCUE/MREVIEW toward
ones.
MREVIEW during stop.
t The head is contaminated. See "Maintenance".
Keep mCUE/MREVIEW pushed
down during playback and release it at t Direct placement of the cassette tape on the speaker
the point you want.
resulted in magnetization and deteriorated tonal quality.
Keep mCUE/MREVIEW pushed up
t Use the unit away from radiowave-emitting devices such
during playback and release it at the
as cellular phones.
point you want.
Tape speed is too fast or too slow in the playback
mode.
t Improper setting of the TAPE SPEED switch. Set it to the
same speed as that used for recording.
t The batteries are weak. Replace both batteries with new
ones.
Tape speed is faster than the normal playback speed.
t The FAST PB switch (M-650V only) is slid in the direction
of the arrow.
Maintenance
To clean the tape head and path
Press n and wipe the head, capstan and the pinch roller with a
cotton swab, moistened with alcohol every 10 hours of use.
To clean the exterior
Use a soft cloth slightly moistened in water. Do not use alcohol,
benzine or thinner.

Specifications

Tape
Recording system
2-track 1-channel monaural
Speaker
Approx. 3.6 cm (1
Tape speed
2.4 cm/s (
Frequency range
300 – 4,000 Hz (with TAPE SPEED switch at 2.4 cm/s)
Input (M-650V only)
Microphone input jack (minijack/PLUG IN POWER)
sensitivity 0.24 mV for 3 k or lower impedance microphone
Output
Earphone jack (minijack) for 8 – 300
Power output (at 10% harmonic distortion)
250 mW
(standard microcassettes) with this
Power requirements
3 V DC batteries size AA (R6) 2/External DC 3V power sources
Dimensions (w/h/d)
Non-standard Approx. 62.2 119.1
Mass
M-650V: Approx. 115 g (main unit only)
M-565V/560V: Approx. 113 g (main unit only)
Supplied accessories
Microcassette tape MC-30 (1) (M-650V for Europe/M-560V for Europe
and U.S.A.)
Microcassette tapes MC-30 (3) (M-565V only)
Alkaline batteries LR6 (2) (M-560V for U.S.A./M-565V)
Approx. 2.5 mm
Design and specifications are subject to change without notice.
Head
Capstan
Pinch roller
(normal position type)
7
⁄ in.) dia.
16
15 15
⁄ ips), 1.2 cm/s ( ⁄ ips)
16 32
earphone
25.4 mm incl. projecting parts and controls