- - - - - - - - - - - - - - - - - - - - MELSEC·A
(b) Automatic online return not provided
In this mode, data communication is executed between the A2C and
a remote I/O module and remote terminal module.
II a communication error occurs with any 01 the modules in the link,
data communication is executed only with modules operating cor-
Once a module is disconnected Irom the link, it cannot restart data
communications when it recovers normal operating state.
To restart data communication with a module disconnected Irom
the link, turn off the power to A2C and then turn it back on again or
reset it with the RUN key switch.
(c) Transmission stop at an occurrence 01 online error
1) II data communication error occurs with anyone 01 the stations
in the link, data communication stops over the entire link.
To restart data communication in the link, turn off the power to
A2C and then turn it back on again or reset it with the RUN key
2) The setting lor the total number 01 stations should be the last
station number 01 remote I/O modules and remote terminal
modules connected to the A2C.
a number is greater than the last station number, such a station
is regarded as the laulty station precluding data communication.
The remote terminal setting is necessary to use remote terminals
modules (up to 14 modules); the setting includes the station number
(a) First station number
The head station number (station number set with the station num-
ber setting switch) 01 the remote terminal modules to be used
should be set lor the station number.
Set attribute lor each remote terminal module.
1) Mitsubishi standard protocol (MINI protocol)
Setting lor remote terminal modules other than RS-232C inter-
lace module (AJ35PTF-R2) should be the Mitsubishi standard
Setting lor an RS-232C interlace module (AJ35PTF-R2) should
be the no-protocol.