30Xa 1702 Module 1/2 - Mche Heat Exchanger (Standard) And 30Xa 1702 Module 1/2 - Cu/Al Heat Exchanger (Option 254/255); 30Xa 1702 Module 2/2 - Mche Heat Exchanger (Standard) And 30Xa 1702 Module 2/2 - Cu/Al Heat Exchanger (Option 254/255) - Carrier Aquaforce 30XA302 Installation, Operation And Maintenance Instructions

3.10 - 30XA 1702 module 1/2 - MCHE heat exchanger (standard) and 30XA 1702 module 1/2 - Cu/Al heat
exchanger (option 254/255)
3.11 - 30XA 1702 module 2/2 - MCHE heat exchanger (standard) and 30XA 1702 module 2/2 - Cu/Al heat
exchanger (option 254/255)
Legend
All dimensions are given in mm.
Required clearances for maintenance (see note)
Recommended space for evaporator tube removal
Water inlet for standard unit
For options 5, 6, 100A, 100C, 107 refer to the certified drawing.
Water outlet for standard unit
For options 5, 6, 100A, 100C, 107 refer to the certified drawing.
Air outlet – do not obstruct
Power supply and control connection
C
Control circuit connection for option 158
To the water inlet of module 2
NOTES:
- Drawings are not contractually binding.
- Before designing an installation, consult the certified
dimensional drawings, available on request.
- For the positioning of the fixing points, weight
distribution and centre of gravity coordinates please
refer to the dimensional drawings.
- If the installation includes several units or if this
(these) is (are) close to walls, please refer to chapters
3.12 - "Multiple chiller installation" and 3.13 -
"Distance to the wall" of this document to determine
the space required.
Water inlet (to be connected to the water
outlet of module 1)
Module 1
15