Editing Recorded Tracks; Erasing Tracks; To Erase A Track; To Erase The Whole Disc - Sony WALKMAN MZ-R50 Operating Instructions Manual

zEditing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
Notes on editing
•Do not move or jog the recorder while "Toc
Edit"* is flashing in the display.
•You cannot edit tracks on an MD that is
record-protected. Before editing tracks,
close the tab on the side of the MD.
*TOC = Table of Contents

Erasing tracks

To erase a track

Note that once a recording has been
erased, you cannot retrieve it. Make sure
of the track you are erasing.
1
Press ERASE while playing the track
you want to erase.
"Erase OK?" and "Push Erase"
appear in the display alternately, and
the recorder plays the selected track
repeatedly. To cancel erasing, press
p.
2
Check the track number in the
display and press ERASE again.
The track is erased from the MD and
the remaining tracks are renumbered.
To erase a part of a track
Add track marks at the beginning and the
end of the part you want to erase, then
erase the part.
p
ERASE

To erase the whole disc

You can quickly erase all the tracks and
data of the MD at the same time.
Note that once a recording has been
erased, you cannot retrieve it. Be sure to
check the contents of the disc you want to
erase.
1
In stop mode, keep pressing ERASE
and press and slide REC to the right.
"All Erase?" and "Push Erase" appear
in the display alternately. To cancel
erasing, press p.
2
Press ERASE again.
"Toc Edit" flashes in the display.
When erasing finishes, "BLANK
DISC" appears.
p
ERASE
REC
21
-EN