Dip Switch Settings - Epson RC700 Manual

2. Hardware

2.2.2 DIP Switch Settings

The board number is set by DIP switch (S2, S3) on the PG board.
The first PG board must be set as shown below:
The second PG board must be set as shown below:
The third PG board must be set as shown below:
The fourth PG board must be set as shown below:
If you purchased the PG board alone, apply the provided board number seal to the board
panel before installing to the controller and be sure to keep a written record of the board
number.
If the board has been already installed before shipment, the board number is properly
configured and there is no need of your further configuration.
NOTE
If you use the PG board for the conveyor tracking, use another address for the PG board of
the PG motion system. For example, if the PG board 1 is used for the conveyor tracking,
then use the PG board 2 for the PG motion system.
6
DIP switch S2
ON
1 2 3 4
DIP switch S2
ON
1 2 3 4
DIP switch S2
ON
1 2 3 4
DIP switch S2
ON
1 2 3 4
DIP switch S3
ON
1 2 3
DIP switch S3
ON
1 2 3
DIP switch S3
ON
1 2 3
DIP switch S3
ON
1 2 3
RC700 / RC90 option PG motion system Rev.2
ON : 0
OFF : 1
4
ON : 0
OFF : 1
4
ON : 0
OFF : 1
4
ON : 0
OFF : 1
4