Sony HVR-Z7E/Z7P Operating Manual page 77

B SEPARATE
Separately applies the AGC for CH1/CH2.
Sound inputs from CH1/CH2 will be
recorded as separate sound.
LINKED
Applies the AGC of CH1 linked with that
of CH2. Sound inputs from CH1/CH2 will
be recorded as a set of sound such as stereo
A
sound. appears on the status check
screen.
b Notes
• This function is available when the CH1 and
CH2 switches are set to AUTO and the INPUT1
and INPUT2 switches are both set to MIC or
both set to LINE (p. 41).
AU.MAN GAIN
x
You can select either linked or separate
audio level control of CH1 and CH2 when
using an external microphone.
B SEPARATE
Separately controls the audio levels of
CH1 and CH2. Sound inputs from CH1
and CH2 will be recorded as separate
sound.
LINKED
Controls the audio level of CH1 linked
with that of CH2. Sound inputs from CH1
and CH2 will be recorded as a set of sound
such as stereo sound.
status check screen.
b Notes
• This function is available when the CH1 and
CH2 switches are set to MAN and the INPUT1
and INPUT2 switches are both set to MIC or
both set to LINE (p. 41).
• When you select [LINKED], you can adjust the
volume with the AUDIO LEVEL dial of CH1
(p. 41).
INPUT1 MIC NR
x
Reduces noise from the microphone.
B ON
Reduces noise from the microphone.
appears on the status check screen.
M
appears on the
OFF
Does not reduce noise from the
microphone.
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
INPUT1 TRIM
x
Adjusts the input signal level from
INPUT1.
You can select from [-18dB], [-12dB],
[-6dB], [0dB], [6dB] and [12dB]. The
default setting is [0dB].
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
INPUT1 WIND
x
B OFF
Disables wind noise reduction.
ON
Enables wind noise reduction.
appears on the status check screen.
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
INPUT2 MIC NR
x
INPUT2 TRIM
x
x INPUT2 WIND
You can set INPUT2 in the same way as
INPUT1.
z Tips
• 48 dBu is set as 0dB in your camcorder.
• Set [INPUT TRIM] to [0dB] for the supplied
microphone (ECM-XM1).
• Set [INPUT TRIM] to [12dB] for the optional
microphone (Sony ECM-NV1).
• The INPUT TRIM function adjusts the input
level from an external microphone. When using
a highly sensitive microphone or recording loud
sound, set this to the minus side. When using a
less sensitive microphone or recording quiet
sound, set it to the plus side.
77
Continued ,