Sony HVR-Z7E/Z7P Operating Manual page 71

Example: TYPE 4
16:9
AE RESPONSE
You can select the speed at which the
automatic exposure adjustment function
follows changes in the brightness of the
subject. You can select the speed from
[FAST], [MIDDLE] and [SLOW]. The
default setting is [FAST].
AT IRIS LMT
You can select the highest iris value for the
automatic adjustment from [F11], [F9.6],
[F8], [F6.8], [F5.6], [F4.8] and [F4]. The
default setting is [F11].
b Notes
• This function is not effective during the manual
iris adjustment.
ECS FREQ.
You can set the shutter speed so that
horizontal strips do not appear on a monitor
screen, which is likely to occur when you
record a monitor screen. Change the setting
with the SEL/PUSH EXEC dial, then press
the dial to confirm the setting. The default
setting is [50.00Hz].
You must set the shutter speed to the ECS
( ) prior to setting this function (p. 31).
You can set the shutter speed in the
following frequency ranges depending on
the setting of [SCAN TYPE]. How to select
[SCAN TYPE] depends on the setting of
[REC FORMAT] of
menu.
4:3
photometric area
(IN/OUT REC)
[HDV1080i]: [HDV PROGRE.] t [REC
TYPE] t [SCAN TYPE]
[DV]: [DV PROGRE.] t [SCAN TYPE]
SCAN TYPE Frequency range
50 50.00 Hz to 200.0 Hz
25 25.00 Hz to 200.0 Hz
FLCKR REDUCE
B ON
Reduces flickering. Flickering of the
screen under a light source such as
fluorescent lamps will be reduced.
OFF
Not reduce flickering. Select this when you
do not want to reduce flickering.
b Notes
• Flickering may not be reduced for certain light
sources.
.
CNTRST ENHCR
When you set this function to [ON], your
camcorder detects high contrast images,
such as backlit scenes, and automatically
improves the unexposed images. The
default setting is [OFF].
b Notes
• When you set [BACK LIGHT] to [ON],
[CNTRST ENHCR] is temporarily disabled.
BACK LIGHT
When you set this function to [ON] (.),
you can correct backlighting. The default
setting is [OFF].
b Notes
• The back light function is canceled when you
set [SPOTLIGHT] to [ON].
SPOTLIGHT
When you set this function to [ON] (
you can prevent overexposure of light
),
71
Continued ,