Default Settings; 3Ct Tool - Siemens AR50M-MF User Manual

Mullion reader
Table of Contents

Advertisement

8 Default settings

Reading MIFARE Classic
Reading MIFARE Plus SL1 – SL3
Reading MIFARE DESFire EV1
Communications mode
Backlight 
Bus address
Wiegand output
Wiegand key PIN burst
Light frame
Tamper/Yellow Connection
Wiegand heart beat mode
Time-out for configuration card (keypad backlight
turns off when this timeout expires subsequent to
last keypress)
Activation time-out
Hold-off time for card read
Reception for card (time before the same card will
be detected in the field again)
Min background illumination
Max background illumination
Off-line indication
Buzzer volume for key press
Buzzer volume for card read
System sound

8.1 3CT Tool

To change the default configuration of the reader, use the 3CT tool. You can purchase the 3CT tool as a
separate download. You can use the 3CT tool to configure MIFARE Classic and DESFire EV1 card
formats to be configured along with Wiegand options to be used for the card readers. For further
information, please contact your local distributor. The 3CT tool configures the format in which user
cards are interpreted by the card reader. The 3CT tool supports configuration of the following
options: Tamper Output / Yellow Input and Heart beat Mode.
© Siemens 2019
UID
UID
UID
OSDP (to change to Wiegand mode remove Jumper 1
and Jumper 3)
Always on (change with 3CT tool)
1 (Up to eight are supported)
26/32/37/56 Bit
4/8 Bits
Follows Red, Green LED inputs in Wiegand mode
Tamper output (change to yellow LED with 3CT tool)
OFF
3 seconds
30 seconds
100 milliseconds
Inactive
12
255
Yes
2
2
10
25
A-100417-b
15.04.2019

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ar20m-mf

Table of Contents