Setting Of Pcs-1 And Hub - Sony PCS-1 System Integration Manual

4-2. Setting of PCS-1 and HUB

The initial setting of the PCS-1 is Auto.
In the Auto setting of the PCS-1, 10/100 can be selected automatically, however, Half/Full cannot be selected
automatically. Therefore, if the HUB is set to Full mode, a connection failure or packet loss occurs. The following table
shows an example of connection between the PCS-1 and Catalyst 2950. When the HUB is set to 100FULL or 10FULL,
change the setting of HUB or adjust the PCS-1 setting to HUB. Refer to "2-5. Service Mode" for the setting procedure of
the PCS-1.
Table of connection between PCS-1 and Catalyst 2950
PCS-1 setting AUTO
2950 settting
AUTO OK
100FULL Packet loss
100HALF OK
10FULL Packet loss
10HALF OK
PCS-1/PCS-1P
100FULL 100HALF
Packet loss OK
OK Packet loss
Packet loss OK
Connection failure Connection failure
Connection failure Connection failure
10FULL 10HALF
Packet loss OK
Connection failure Connection failure
Connection failure Connection failure
OK Packet loss
Packet loss OK
4-3