Sony PCS-1 System Integration Manual page 72

4. The LAN set menu of teleconference terminal A is set as described below.
DHCP mode:
Host name:
IP address:
Network mask:
Gateway address:
DNS address:
Gatekeeper used:
Gatekeeper address:
User name:
User number:
SNMP service:
Trap transmission destination: Blank
Community name:
Description of device:
Installation place:
Contact of administrator:
NAT setting:
NAT address:
Packet retransmission request: Blank
Optimum rate control:
Port number used:
TCP port number:
UDP port number:
5. Confirm that the IP address displayed in the launcher menu of teleconference terminal A is
192.100.10.10.
6. Confirm that Registration Confirm is displayed at the bottom of page 2/5 in the LAN set menu of
teleconference terminal A.
7. Enter LAN in the dial list of teleconference terminal A for a line type, user name PCS1B or user
number 200 of teleconference terminal B in it for an IP address, and other required items. After that,
register teleconference terminal B and initiate a call. Or set LAN for a line type and user name
PCS1B or user number 200 of teleconference terminal B for an IP address by dialing, and then
initiate a call.
3-10
ON
Enter any name.
Blank
Blank.
Blank
Blank
ON
192.100.10.20
Enter any name. (Example: PCS1A)
Enter any number. (Example: 100)
OFF
public
Videoconference Device
Blank
Blank
OFF
Blank
OFF (Set to ON when a packet loss occurs frequently.)
Specified value (Set to "User setting" when a port number is specified
by the network administrator.)
2253 (Enter the port number specified by the network administrator
when the port number used is set to "User setting".)
49152 (Enter the port number specified by the network administrator
when the port number used is set to "User setting".)
PCS-1/PCS-1P