Sony PCS-1 System Integration Manual page 66

Communication system
Hide thumbs Also See for PCS-1:
Table of Contents

Advertisement

3. The LAN set menu of teleconference terminal A is set as described below.
DHCP mode:
Host name:
IP address:
Network mask:
Gateway address:
DNS address:
Gatekeeper used:
Gatekeeper address:
User name:
User number:
SNMP service:
Trap transmission destination: Blank
Community name:
Description of device:
Installation place:
Contact of administrator:
NAT setting:
NAT address:
Packet retransmission request: Blank
Optimum rate control:
Port number used:
TCP port number:
UDP port number:
4. Confirm that the IP address displayed in the launcher menu of teleconference terminal A is
192.100.10.10.
5. Enter LAN in the address book of teleconference terminal A for a line type, IP address 192.100.20.20
of teleconference terminal B in it for an IP address, and other required items. After that, register
teleconference terminal B in the address book and initiate a call. Or set LAN for a line type and IP
address 192.100.20.20 of teleconference terminal B for an IP address by dialing, and then initiate a
call.
3-4
OFF
Enter any name.
Local IP address (192.100.10.10)
Depends on a network. Usually, set to 255.255.255.0.
192.100.10.1
Blank
OFF
Blank
Blank
Blank
OFF
public
Videoconference Device
Blank
Blank
OFF
Blank
OFF (Set to ON when a packet loss occurs frequently.)
Specified value (Set to "User setting" when a port number is specified
by the network administrator.)
2253 (Enter the port number specified by the network administrator
when the port number used is set to "User setting".)
49152 (Enter the port number specified by the network administrator
when the port number used is set to "User setting".)
PCS-1/PCS-1P

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pcs-1pPcs-a300Pcs-a1

Table of Contents