Maintenance & Storage - Bissell 1620 User Manual

Cleaning Technique
Connect the Tough Stain Tool to the Flex Hose.
1.
Plug into a proper outlet and turn the Power Switch ON.
2.
While pressing the trigger, slowly move the spraying tool back
3.
and forth over the soiled surface. Release the trigger to suction
soiled water.
Continue to clean soiled area, working in small sections, until
4.
no more dirt can be removed.
Caution: Do not overwet.
When the cleaning job is complete, refer to the
5.
Maintenance/Storage section below.
Maintenance/Storage
Turn Power Switch OFF. Make sure to switch SmartMix Dial to
1.
WATER ONLY.
Unplug Power Cord from outlet and wrap cord around the
2.
Quick Release Cord Wrap.
Remove and rinse tools in clean water. Dry and replace.
3.
Coil Flex Hose through Flex Hose Storage Brackets.
4.
Remove Tank-in-Tank. Dispose of dirty water. See The Basics
5.
section, page 8.
12
Quick Release
Cord Wrap™
Flex Hose
Storage Bracket
CAUTION:
PowerLifter Plus uses water
and must not be stored
where there is a danger of
freezing. Freezing will
damage internal components
and void the warranty.