Inverter Component Names - Mitsubishi Electric 800 Series Hardware Instruction Manual

1.2

Inverter component names

Component names are as follows.
(a)
(d)
(b)
(c)
(e)
(f)
Symbol Name
(a) RS-485 terminals
(b) Plug-in option connector 1
(c) Plug-in option connector 2
(d) Plug-in option connector 3
(e) Voltage/current input switch
(f) Control circuit terminal block
(g) PU connector
(h) USB A connector
(i) USB mini B connector
(j) Front cover (upper side)
(k) Power lamp
(l) Alarm lamp
(m) Charge lamp
(n) Operation panel (FR-DU08)
(o) Front cover (lower side)
(p) Main circuit terminal block
(q) Cooling fan
Switches (SW3 and SW4) for
(r)
manufacturer setting
(g)
(h)
(i)
(r)
(j)
(k)
(l)
(n)
(m)
(o)
Enables RS-485 communication.
Connects a plug-in option or a communication option.
Selects between voltage and current for the input via terminals 2 and 4.
Connects cables for the control circuit.
Connects the operation panel (FR-DU08) or the parameter unit (FR-PU07). This
connector also enables the RS-485 communication.
Connects a USB memory device.
Connects a personal computer and enables communication with FR
Configurator2.
Remove this cover for the installation of the product, installation of a plug-in
(communication) option, RS-485 terminal wiring, switching of the voltage/
current input switches, etc.
Stays ON while the power is supplied to the control circuit (R1/L11, S1/L21).
Turns ON when the protective function of the inverter is activated.
Stays ON while the power is supplied to the main circuit.
Operates and monitors the inverter.
Remove this cover for wiring.
Connects cables for the main circuit.
Cools the inverter.
Do not change the initial setting (OFF
Description
OFF
).
ON
1.2 Inverter component names
1
2
(q)
3
4
5
6
7
8
9
10
(p)
Refer to page
63
Instruction
Manual of the
option
*1
44
61
62
62
21
39
96
39
*1
21
38
107
—
15
1. INTRODUCTION