American Standard SELECTRONIC 606B2 Series Installation Instructions Manual page 9

INSTALL COVER PLATE; Fig. 12
10
1. Install the two TABS (1) on the back side of COVER
PLATE (2) into the two SLOTS (3) located on the top
edge of the ELECTRICAL BOX (4).
2. Push on the bottom edge of the COVER PLATE (2)
until it snaps into place. If COVER PLATE (2) will not
snap into place, then loosen the MOUNTING SCREWS
(6) on the ELECTRICAL BOX (4) slightly.
To remove COVER PLATE (2), insert WIRE KEY (5)
3.
(supplied) into the two holes located at the bottom of
the COVER PLATE (2). Push the WIRE KEY (5) up until
it releases the bottom clips. Pull the bottom edge away
and lift the COVER PLATE (2) off.
CONNECT OVERRIDE HOSES,
11
AC & DC POWER; Fig. 13
Push the BLACK HOSE (1) into the BOTTOM HOSE
1.
CONNECTOR (2) on flush valve body and push the
other end into the back of the MANUAL OVERRIDE
VALVE (3).
Push the BLUE HOSE (4) into the TOP HOSE
2.
CONNECTOR (5) on flush valve body and push the
other end into the BOTTOM CONNECTOR (6) of the
manual override valve.
Fig. 12
3
4
6
2
PUSH TO
SNAP PANEL
INTO PLACE
Fig. 13
1
BLACK
HOSE
4
BLUE
HOSE
5
2
9
1
5
3
6
M965640 Rev. 1.4 (11/17)
2