Dubbing To Another Equipment; Connections For Dubbing - Sony 1080i Operating Instructions Manual

Dubbing to another equipment

This section describes the connections and settings
necessary to perform dubbing on other equipment,
using this unit as a video player.

Connections for Dubbing

Notes
• For connection of the editing controller and its
peripheral devices, refer to the instruction manual of
the editing controller and that of the editing software
you use.
• Edit functions are specified by the editing software.
For details on the editing methods, refer to the
instruction manual of the editing software.
• You cannot use the DSR-25/45-equipped duplicate
function to dub a tape recorded in HDV/DV format
via the i.LINK connection. Use the procedure in this
chapter to perform dubbing.
To digital video equipment with an i.LINK
jack
Connect this unit to the recorder as shown below using
an i.LINK cable.
The signal flow is automatically detected so you do not
need to make separate connections for input and
output. Also, connecting the unit to an editing
controller via HDV/DV jacks, you can configure a
digital non-linear editing system.
For connections of the editing controller and this unit, refer
to the editing controller instruction manual.
Dubbing/Editing
Before dubbing, you must set the format in which you
want to output signals. Perform the [VCR HDV/DV]
(p. 48) and [i.LINK CONV] (p. 49) settings of the [IN/
OUT REC] menu.
For details, refer to "Compatibility of HDV, DVCAM, and
DV Formats" (p. 68).
Chapter
Rear view of the player
(this unit)
i.LINK cable (not supplied)
i.LINK jack
Digital video
equipment with an
i.LINK jack
Chapter 3 Dubbing/Editing
3
Monitor
Monitor
: Signal flow
(Continued)
35