Pre-Treating; Deep Cleaning; Attaching The Bare Floor Tool - Bissell QUICKSTEAMER 1950 User Manual

Pre-Treating (Optional)
Pre-treat stubborn stains and highly soiled carpet in
hallways and other high-traffic areas.
Spray soiled area with BISSELL
1.
Use a stiff-bristled brush to work formula into carpet pile.
2.
Wait 3 -5 minutes before deep cleaning.
3.

Deep Cleaning

Turn Power Switch [back of Lower Body] to (
1.
With foot, press the Detent Pedal on right side of Lower Body.
2.
3. Depress Trigger to spray cleaning solution. Do not overwet.
Repeat motion over same area without depressing Trigger.
4.
Repeat Steps 3 and 4 until no more dirt can be removed.
5.
Continue to clean entire carpet, working in 3' x 4' sections.
6.
Empty the Dirty Water Tank when dirty water reaches the full
7.
line, or when the Clean Water Tank is empty.
If Floor Nozzle stops spraying, turn Power Switch to
8.
OFF ( ) and check water and cleaning solution levels.
Refill if needed.

Attaching the Bare Floor Tool

*Available with select models only. If your QuickSteamer did not
come so equipped, you may call BISSELL Consumer Services
at 1-800-237-7691 to order one. You can also visit the BIS-
SELL website: www.bissell.com.
NOTE: Your QuickSteamer is not recommended for cleaning
wood floors.
• Use only BISSELL ® Floor Cleansing Formula
floors. Never use BISSELL Fiber Cleansing Formula
carpet cleaners on bare floors.
• Sweep or vacuum before starting.
• Remove old wax before cleaning.
• Leave an exit path for yourself.
• Allow at least 1/2 hour drying time.
® Tough Stain PreCleaner. ™
) ON.
™ on no-wax
™ or other
Tip:
Deep cleaning
spots, spills
and high traffic
areas on a
regular basis can
prolong
carpet life.
Tip:
Deep cleaning
carpeting
regularly can
reduce dust
and allergens
in your home.
7.
Dirty Water Tank
Bare Floor Tool
(select models only)