DVG-N5402SP Wireless Router with 1 FXS Port
User Manual
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
configure VoIP, specify the settings of the firewall, etc.).
For security reasons, DVG-N5402SP with default settings cannot connect to the Internet.
!
To get started, please set your own password used to access the web-based interface and, if
needed, configure other settings recommended by your ISP.
Start a web browser (see the Before You Begin section, page 14). In the address bar of the web
browser, enter the IP address of the router (by default, the following IP address is specified:
192.168.8.254). Press the Enter key.
Figure 12. Connecting to the web-based interface of the DVG-N5402SP device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the Initial
Configuration Wizard section, page 30).
Figure 13. The page for running the Initial Configuration Wizard.
Page 23 of 188
Installation and Connection