Troubleshooting - Bissell ProHeat 7950 SERIES User Manual

Troubleshooting

Powerdrive does not seem to be engaged.
Possible Causes
1
Handle not fully engaged with Powerdrive position
2
SmartTemp Ready Light does not illuminate.
Possible Causes
1
2
Reduced spray or no spray.
Possible Cause
1
2
3
4
5
6
20
The Powerdrive is in the OFF position
The SmartTemp Switch is not turned ON ( I )
The machine Power Switch is not
turned ON ( I ).
Bladder may be empty.
SmartMix Tank may be empty.
The filter may be clogged.
Tanks may not be seated properly.
Pump may have lost prime.
The Pump Belt may be broken.
Insert
Screwdriver
Blade Here
Remedies
1
2
Remedies
1
2
Remedies
1
2
3
4
5
6
Lift Here
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
Turn the Powerdrive Knob to the "ON" Position
Push handle in as far as it will go to feel the
most impact
Turn on the SmartTemp Switch
Both switches must be ON ( I ) to
activate the SmartTemp Ready Light.
Refill Bladder with hot tap water.
Fill with BISSELL deep cleaning formula
for cleaning or water if
rinsing,or using the Scotchgard
protector applicator.
Clean out Flow Indicator Filter, page 17.
Turn power OFF; remove & reseat
tanks. Inspect for presence of seals.
Turn power OFF; after 1 minute turn
ON and depress Trigger.
Turn the machine OFF and unplug
from the outlet. To check if a Pump
Belt has broken, you will need a flat
head screwdriver. Insert the blade end
into the lower slot of the Belt Access
door to release the lower snap. If
necessary, insert the blade end into
the upper slot to release the upper
snap. Examine the belt for breakage.
You should be able to see the Pump
Belt looped around the motor shaft. If
it is broken or missing, please refer to
Replacement Parts on page.23 before
calling Consumer Services. Complete
installation instructions will
accompany the replacement belt.