Siemens SIMATIC PN/M-Bus LINK Operating Instructions Manual page 27

Mounting to a control panel
Preparations
● Drill holes (M4). The dimensions for the drill holes are available in the figure below.
Mounting
Proceed as follows:
1. Move the sliders
2. Tighten the PN/M-Bus LINK. Use a cylinder head screw M4 as well as a spring lock
washer and a flat washer for this.
Figure 6-2
PN/M-Bus LINK
Operating Instructions, 03/2018, A5E44260928-AA
①
to the outside until they latch in place.
NOTICE
Do not use a countersunk head screw.
The type of screw required depends on the type of material on which the module is
mounted. Fasten the screw with the corresponding torque until the spring lock washer is
pressed flat.
Do not fasten the screws with excessive torque.
Control panel mounting of the PN/M-Bus LINK
Mounting/Extending
6.1 Installing the device
25